User manual WHIRLPOOL AKZ 501/IX/01 INSTRUCTION FOR USE

[. . . ] Do not touch the heating elements in the oven. • This oven is designed solely for use as a home appliance for cooking food. The manufacturer assumes no responsibility for damage caused by improper or incorrect use. 12 • Any repairs or servicing must be carried out exclusively by a qualified technician. [. . . ] • Do not place inflammable material in the oven or nearby: a fire may break out if the oven is inadvertently switched on. • Use oven gloves to remove pans and accessories, when the oven is hot. • If alcoholic beverages are added when roasting or cooking cakes and sweets (for example, rum, cognac, wine, etc. ) remember that alcohol evaporates at high temperatures. It may happen that vapours released by the alcohol can catch fire when they are in contact with the electric heating element. • Do not heat sealed containers in the oven (except for packages specifically designed for this purpose; see the manufacturer’s instructions). The pressure that develops inside the packaging might cause it to explode, damaging the oven. • Do not use containers made of synthetic material for cooking (except for packages specifically designed for this purpose; see the manufacturer’s instructions). • Keep an eye on the oven if you are using a lot of fat or oil. Oil and fat can overheat and catch fire!• Never pull out fully loaded shelves. Use extreme BEFORE USING THE OVEN • Remove the accessories from the oven and heat it 200°C for about an hour to eliminate the smell of the protective grease and insulating materials. • Slight differences in colour on the front of the appliance are determined by the different materials used, such as glass, plastic and metal. Ovens with aluminium front panel • Clean using a delicate detergent and a soft window cleaning cloth or a microfibre cloth that does not leave fibres on the surface. Wipe horizontally, without exerting pressure. • Do not use corrosive products, hard sponges or rough cloths. Clean the aluminium surfaces with a dry cloth. Self-cleaning catalytic side panels and rear cavity (if provided) - Cleaning cycle • Heat the oven to 200° C when empty and maintain this temperature for about an hour. • At the end of the cycle and when the oven has cooled, use a damp sponge to remove any food residues. • Never clean the self-cleaning catalytic panels and rear cavity with abrasive products, rough brushes, pan scourers, or oven cleaner sprays, as they will lose their automatic cleaning properties. Accessories • Soak the accessories in water with washing up detergent immediately after use. Food residues can be easily removed using a brush or sponge. 15 31002018GB. fm Page 16 Tuesday, December 2, 2008 10:29 PM Attention: When carrying out the following operations it is advisable to wear protective gloves. These instructions should be carefully followed both to prevent injury and in order not to damage the oven door and hinges. Lift the two catches and push them forwards as far as they go (see fig. Remove the door by closing it partially and pulling it upwards (see fig. Insert the hinges into their grooves and lower the door fully. [. . . ] Carefully remove the halogen lamp from the ceramic holder and replace it with a new one (see note). Reposition the lamp cover and press it against the oven wall until it clicks correctly into place. Reconnect the oven to the electrical supply. Note: Use only 20 W/12 V, G4 type, T300°C bulbs, available from After Sales Service. [. . . ]