User manual WHIRLPOOL AKZ520NB

[. . . ] All safety warnings give specific details of the potential risk present and indicate how to reduce risk of injury, damage and electric shock resulting from improper use of the appliance. Carefully observe the following instructions: - The appliance must be disconnected from the power supply before carrying out any installation work. - Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer’s instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. [. . . ] Lift the catches and push them forwards as far as they will go (Fig. Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (Fig. Pull the heating element out a little (Fig. To reposition the heating element, lift it up, pulling it slightly towards you, making sure it comes to rest on the lateral supports. Disconnect the oven from the power supply. 6), replace the lamp (see note for lamp type) and screw the lamp cover back on. to replace the side lamp (if present): 1. Disconnect the oven from the power supply. Remove the side accessory holder grilles, if present (Fig. Use a screwdriver to prise off the lamp cover (Fig. Replace the lamp (see note for lamp type) (Fig. Turn the adjustment knob to display the desired cooking time. To confirm the cooking time, press button 3 . The oven automatically confirms your selection 10 seconds after the last operation. SETTING END OF COOKING TIME/START DELAYED IMPORTANT: the start delayed setting is not available for the following functions: FAST PREHEATING, BREAD/PIZZA, GENTLE CONVECTION BAKE. : with this setting, the selected temperature is reached in a more gradual way, so cooking times will be slightly longer than stated in the cooking table. The end of cooking time can be set, delaying the start of cooking by up to a maximum of 23 hours and 59 minutes. This can only be done once cooking time has been set. After setting cooking time, the display shows the end of cooking time (for example 15:45) and the symbol flashes. To delay the end of cooking time, and thus also the cooking start time, proceed as follows: 1. Turn the “Browse” knob to display the time you wish cooking to end (for example 16:00). Confirm the selected value by pressing button 3 : the two dots of end of cooking time flash, indicating that the setting has been made correctly. [. . . ] Use dark coloured metal cake tins and always position them on the wire shelf supplied. To cook on more than one shelf, select the forced air function and stagger the position of the cake tins on the shelves, aiding optimum circulation of the hot air. To check whether a raising cake is cooked, insert a wooden toothpick into the centre of the cake. If the toothpick comes out clean, the cake is ready. [. . . ]