User manual WHIRLPOOL AKZM 654/IX INSTRUCTION FOR USE

[. . . ] Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer’s instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. Regulations require that the appliance is earthed. The power cable must be long enough for connecting the appliance, once fitted in its housing, to the power supply socket. [. . . ] Reposition the lamp cover, pushing it on firmly until it snaps into place (Fig. Refit the side accessory holder grilles. Reconnect the oven to the power supply. Fig. 9 N. B. : Only use 25-40W/230V type E-14, T300°C incandescent lamps, or 20-40W/230 V type G9, T300°C halogen lamps. Lamps are available from our After-sales Service. IMPORTANT: If using halogen lamps, do not handle with bare hands since fingerprints can damage them. Do not use the oven until the lamp cover has been repositioned. GB5 INSTRUCTIONS FOR OVEN USE FOR ELECTRICAL CONNECTION, SEE THE PARAGRAPH ON INSTALLATION 1. Circular heating element (not visible) 7. Position of shelves (the number of shelves is indicated on the front of the oven) 12. Rear wall NOTE: During cooking, the cooling fan may switch on at intervals in order to minimise energy consumption. At the end of cooking, after the oven in switched off, the cooling fan may continue to run for a while. Turn the adjustment knob to display the desired cooking time. To confirm the cooking time, press button . The oven automatically confirms your selection 10 seconds after the last operation. SETTING END OF COOKING TIME /START DELAYED Important: the start delayed setting is not available for the following functions: FAST PREHEATING, BREAD/PIZZA. N. B. : with this setting, the selected temperature is reached in a more gradual way, so cooking times will be slightly longer than stated in the cooking table. The end of cooking time can be set, delaying the start of cooking by up to a maximum of 23 hours and 59 minutes. This can only be done once cooking time has been set. After setting cooking time, the display shows the end of cooking time (for example 15:45) and the symbol flashes. To delay the end of cooking time, and thus also the cooking start time, proceed as follows: 1. Turn the “Browse” knob to display the time you wish cooking to end (for example 16:00). Confirm the selected value by pressing button : the two dots of end of cooking time flash, indicating that the setting has been made correctly. The oven will automatically delay the start of cooking so as to finish cooking at the set time. At any time, however, set values (temperature, grill setting, cooking time) can be changed using button to go back, followed by the “Browse” knob to change values and button to confirm. INDICATION OF THE RESIDUAL HEAT INSIDE THE OVEN If at the end of cooking, or when the oven is switched off, the temperature inside the oven is over 50°C, the display shows the word HOT and the current temperature. [. . . ] Cooking temperatures and times are purely for guidance and will depend on the amount of food and type of accessory used. Use the lowest recommended values to begin with and, if the food is not cooked enough, then move on to higher values. Use the accessories supplied and preferably dark coloured metal cake tins and oven trays. You can also use pans and accessories in pyrex or stoneware, but bear in mind that cooking times will be slightly longer. [. . . ]