User manual WHIRLPOOL ALA 001 INSTRUCTION FOR USE

[. . . ] Operating Instructions Tumble dryer Imesa ES7PEE Contents Before using your machine for the first time Do not tumble-dry Safety instructions Installation Safety Interrupting a programme Packing material Recycling Child safety General Activating/deactivating Child-safe start Description of the tumble dryer Front panel Advice and tips before you tumble-dry Have the clothes been spun?Materials that can be tumble-dried Materials that must not be tumble-dried Static electricity Tumble drying Sort your fabrics Turn on the main power switch. Open the door, load the items and then close the door Select the programme Press the Start button Drying programme finished Once drying has finished Settings How to choose the settings: Language Child-safe Audible Volume Element 2 3 3 4 4 4 4 4 5 6 6 6 7 8 9 9 9 9 9 10 10 10 10 10 12 12 12 13 13 13 13 13 13 Care and cleaning Cleaning the lint filter Cleaning the outside of the machine Troubleshooting The machine will not start Overheating cut-out Drying takes too long The washing does not dry, or is too dry Error messages Technical information Technical data Standard tests Service Before contacting the service division Installation Positioning the tumble dryer Adjusting the feet Air evacuation Electrical installation Door hanging Follow these instructions: Quick guide Fabrics Turn on the main power switch Load the garments Select a programme and any options Press the Start button Drying programme finished Once drying has finished 14 14 14 15 15 15 15 15 15 16 16 16 17 17 18 18 19 19 21 22 23 24 24 24 24 24 24 24 24 2 Before using your machine for the first time Do not tumble-dry Certain materials are not suitable for tumble-drying. Always check and follow the instructions on each item's laundry label. [. . . ] The programme will not be affected if you change the programme selector after the programme has started. Caution! If the lint filter becomes clogged, the machine’s automatic overheating cut-out may be triggered. Press the Stopbutton once to save the setting. 13 Care and cleaning Cleaning the lint filter If the display reads "Insert filter" the tumble dryer will not start. The lint filter must be cleaned after each load. If you have very hard water, this can cause limescale deposits in the lint filter. Check for any limescale deposits when cleaning the lint filter and, if necessary, wash the filter by hand. Grasp the filter handle and pull it towards you. Pull the filter out of its holder. Cleaning the outside of the machine Clean the outside of the machine and the programme panel with a mild cleaner. Do not use solvents, as these can damage the machine. Do not hose down or spray the machine with water. Do not allow dust to accumulate around the machine. Keep the area around the tumble dryer clean and cool; dust, heat and moisture prolong drying times. 3. Open the filter and remove the lint from all sides of it by hand. Use a soft, dry cloth to remove any deposits. 4. Replace the filter in its holder. Note!If you have hard water, the filter should be washed with water to get rid of any limescale deposits. Use a sponge and a little dishwashing detergent if necessary. If you cannot remove the limescale, you can buy a new filter from the retailer where you bought the tumble dryer. 14 Troubleshooting The machine will not start Check • that the door is properly closed. • that the main power switch is on. • that the fuses (circuit breakers) in your house are intact. Swap two circuit breakers over to make sure. You cannot always tell from the outside if a circuit breaker is broken. • that the overheating cut-out has not been triggered (see below). [. . . ] More bends will reduce the tumble dryer’s fan capacity. Installation in a hot environment If you install the tumble dryer in a small room with a high atmospheric humidity, where the temperature may exceed 25°C, there is a risk of condensation accumulating in a kink and obstructing the air flow, resulting in poor drying results. To avoid this happening, the hose must not be fitted so that it goes up (a), but instead so that it is horizontal (b) or goes down (c) from the drier. a a Examples of installations b c Caution!Air from the tumble dryer must not be fed through ducts used for equipment that burns gas or other fuels. 20 Installation Accessories If the vent hose runs to an outlet in the wall, you can prevent the inflow of cold air by fitting a ventilation grill. This grill can be installed either outside or inside. Electrical installation The electrical connection must be made using a cable for permanent installation, with a multipolar circuit breaker, by a qualified professional. Connection on delivery The machine is supplied as 1-Phase, 230V, 50Hz, heat output 3000W and has a 16A plug. [. . . ]