User manual WHIRLPOOL AMB 857/G INSTRUCTION FOR USE

[. . . ] INSTRUCTIONS FOR USE SINGLE SPLIT AIR CONDITIONER WITH GREEN GAS AND WITH GAS R22 PREPARATION BEFORE USE SAFETY PRECAUTIONS IDENTIFICATION OF PARTS REMOTE CONTROL OPERATION INSTRUCTIONS MAINTENANCE TROUBLESHOOTING PROTECTION INSTALLATION INSTRUCTIONS ELECTRICAL CONNECTION CLASSIC RANGE R22 GREEN RANGE Disposal of old appliances • This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ] Refit and close the front panel • Refit and close the front panel by pushing it downwards as shown in the figure (b). Clean the air filter It is advisable to clean the air filter after approx. Stop the appliance and remove the air filter 1. Press the air filter handle gently, the filter will spring out. Replace the filter in its original position after cleaning If the filter is very dirty, clean it with a solution of lukewarm water and neutral detergent, then dry it in the air. IMPORTANT: Clean the air filter every two weeks when the air conditioner is operated in a dusty environment. TROUBLESHOOTING Trouble Does not run Analysis • • • • • • • • • • • • • • Is the protection device or fuse blown?Sometimes it stops working to protect the appliance. Are the intakes and outlets of the air conditioner obstructed. If there is a strong interference (from excessive static electricity discharge, power supply voltage abnormality) presents, operation will be abnormal. In this case, unplug from the power supply and plug in after 2-3 seconds. Changing mode in operation, there may be a delay of 3 minutes. This odour may come from another source such as furniture or others. Caused by the flow of refrigerant in the air conditioner, not a fault. Caused by the expansion or contraction of the front panel because of temperature changing, not a fault. Mist appears when the room air becomes very cold as during operation in “COOLING” or “DRY” mode. The unit is shifting from heating mode to defrost. The indicator will turn off within ten minutes and return to heating mode. No cool or warm air Ineffective control Does not operate immediately Peculiar smell A sound of running-water A “pixi” sound can be heard Spray mist from the outlet The compressor indicator (red) lights up constantly, and the indoor fan stops. 147 PROTECTION Operating condition The protective device may trip and stop the appliance in the cases listed below. Outdoor air temperature is over 24°C *HEATING Outdoor air temperature is below -7°C Room temperature is over 27°C COOLING DRY Outdoor air temperature is over* 43°C Room temperature is below 21°C Room temperature is below 18°C *For Tropical (T3) Climate condition models, the temperature point is 52°C instead of 43°C. If the air conditioner runs in “COOLING” or “DRY” mode with door and/or window open when relative humidity is higher than 80%, dew will drip down from the outlet. Features of protection device • The protection device will trip in the following cases: - Restarting the unit at once after operation stops or changing mode during operation, you need to wait 3 minutes. - After connecting to power supply and turning on the appliance immediately, there may be a delay of 20 seconds before it starts to operate. - If all operation has stopped, press ON/OFF button again to restart, Timer should be set again if it has been cancelled. Noise pollution • Install the air conditioner in a place that can bear its weight in order to operate more quietly. • Install the outdoor unit in a place where the air discharged and the operating noise do not annoy your neighbours. • Do not place an obstacle in front of the outlet of the outdoor unit as it may affect the air conditioner operation and increase the noise level. HEATING mode features Preheating 2-5 minutes are necessary to preheat the evaporator at the beginning of HEATING operation, so that cold air is not discharged. Defrosting In HEATING mode the appliance will defrost automatically to raise efficiency. [. . . ] Connect the wires to the terminals on the control board individually as follows. - Secure the power connecting cord on the control board with a cable clamp. - Refit the access door in the original position and tighten the screw. - Use a recognized circuit breaker for 24-30 K models between the power source and the unit. [. . . ]