User manual WHIRLPOOL AMD 381 INSTRUCTION FOR USE

[. . . ] Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 22 PREPARATION BEFORE USE Before using the air conditioner, be sure to check and preset the following. • Remote Control presetting Each time the batteries are replaced in the remote control, the remote control is pre-set on Heat Pump. [. . . ] • The previous set time is stored and the next set time begins with the previous setting. • On- timer and off-timer can not be set at the same time. • The room may not reach your desired temperature within the preset time; this depends on the size of the room. High hr Low 2 2 SWING MODE FAN SLEEP TIME 1 1. setting the next operation after 9. 5 hours Set the desired operating mode, temperature and indoor fan speed, then press the TIMER button (1); “h” will flash on the LCD. High hr Low 2. setting the next operation after 9. 5 hours Point the remote control at the signal receiver of the indoor unit, and press the or button (2) when “h” flashes. Choose the time you desire, then press the TIMER button. A “beep” can be heard: • Timer indicator on the indoor unit lights up. Important: Press the TIMER button, “h” flashes on the LCD, then you can set the time. Each time the or button is pressed: If the desired time is within 10 hours, the set time increases or decreases by 0. 5 hour. If the desired time is beyond 10 hours, the set time increases or decreases by 1 hour. The time that can be set ranges between 0. 5 and 24 hours. High hr Low 3. • Do not place an obstacle in front of the outlet of the outdoor unit as it may affect the air conditioner operation and increase the noise level. HEATING mode features Preheating 2-5 minutes are necessary to preheat the evaporator at the beginning of HEATING operation, so that cold air is not discharged. Defrosting In HEATING mode the appliance will defrost automatically to raise efficiency. This procedure usually takes 2-10 minutes. After defrosting completes, it returns to HEATING mode automatically. Note: Heating is NOT available for cooling only air conditioner models. 32 INSTALLATION INSTRUCTIONS Distance from wall should be over 50 mm Distance from ceiling should be over 50 mm Installation diagram Distance from the wall should be over 50 mm Distance from floor should be over 2000 mm Air intake distance from the wall should be over 250 mm Air intake distance from the wall should be over 250 mm Air sho outle uld t di be stan ove ce r 5 from 00 mm the wa ll Over 250 mm NOTE: The figure above is only a simple presentation of the unit, it may not match the external appearance of the unit you purchased. Installation must be performed in accordance with the national wiring standards by authorised personnel only. 33 Select the best location Location for Installing the Indoor Unit • Where there is no obstacle near the air outlet and air can easily be blown to every corner. • Where piping and wall hole can easily be arranged. • Observe the required distance from ceiling and wall according to the wiring diagram. • Where the air filter can easily be removed. • Keep the unit and remote control 1 m or more from the television, radio etc. • To prevent the effects of a fluorescent lamp, keep the unit as far as possible. • Do not put anything near the air inlet that could obstruct it. [. . . ] The fuse for the whole unit is to be provided by the user according to the current at maximum power input or use another over-current protective device instead. • The power connection for the air conditioner has to be made at the main power distribution which has to be of a low impedance. In order to ensure the suitability of the equipment for connection, the user should consult the supply authority, if necessary, to check that the service current capacity at the interface point is sufficient for the equipment. Refer to the rating plate of the equipment for power consumption details. [. . . ]