User manual WHIRLPOOL AMD 398 INSTRUCTION FOR USE

[. . . ] Never insert a stick or similar to the unit. Since the fan rotates at high speed, this may cause injuries. It is harmful to your health if the cool air reaches you for a long time. It is advisable to make the air flow be deflected to all the room. Turn off the appliance first before cutting off power supply when malfunction occurs. [. . . ] If the dirt is conspicuous, wash it with a solution of detergent in lukewarm water. Reinstall the filter and close theinterior air inlet grille. air filter 9 OPERATION TIPS Operating condition The protective device maybe trip and stop the appliance in the cases listed below. Outdoor air temperature is over *43°C COOLING Room temperature is below 21°C *For Tropical (T3) Climate condition models, the temperature point is 52°C instead of 43°C. If the air conditioner runs in COOLING mode with door or window opened for a long time when relative humidity is above 80%, dew may drip down from the outlet. Noise pollution The noise level of air conditioner sounds higher at night than in the daytime. Please set LOW FAN SPEED or FAN ONLY mode at night in order to decrease noise. Features of protective device The protective device will work at following cases. • Restarting the unit at once after operation stops or changing mode during operation, you need to wait 3 minutes. • Connect to power supply and turn on the unit at once, it may start 20 seconds later. Use proper fuse Do not use wire or anything else instead of fuse. Otherwise, air conditioner will be damaged, or cause stock, fire, etc. You need to wait 3 minutes before restarting. (Note: If you let the appliance on after power cut, the compressor may be burned) Note In very humid areas, the water removal may be excessive enough to overflow the unit or increase the noise of the air conditioner. If this occurs, you may wish to attach a drain hose (not included) to the drain plug allowing condensations to run off conveniently. Drain hose (not included) 10 ELECTRICAL SPECIFICATIONS 1. All wiring must comply with local and national electrical codes and must be installed by a qualified electrician. If you have any questions regarding the following instructions, contact a qualified electrician. Check available power supply and resolve any wiring problems BEFORE installing and operating this unit. This unit is grounded through the power cord when plugged into a matching wall outlet. If you are not sure whether your wall outlet is properly grounded, please consult a qualified electrician. The wall outlet must match the plug on the service cord supplied with the unit. DO NOT use plug adapters or extension cord. The rating plate on the unit contains electrical and other technical data. The rating plate is located on the cabinet of the unit. [. . . ] 7) and the decorating strip is presented for aesthetical appearance as Fig. 8. lower part of installation bracket buffer Fig. 8 Drainage Condensate will form during the cooling or dry operation, user can choose drainage or no drainage. Remove the drainage tip and fix the drainage hose when drainage is chosen. [. . . ]