User manual WHIRLPOOL AQUASENSE C INSTRUCTION FOR USE

[. . . ] Curtains and delicate clothing, dresses skirts, shirts and blouses. Only woollens, labelled with the woolmark and identified as machine washable. This programme (40°C) is tested and approved by The Woolmark Company for machine washable wool. If you select “Rinse Hold” do not leave items to soak for too long. [. . . ] Same as the spin cycle in the “Wool” programme. Alternative method of terminating programme after “Rinse Hold”. ❉ — — — ❉ — — — Spin Centrifugeren Gentle Spin Kort centrifugeren Drain Afpompen ❉: 1) 2) optional / Yes : dosing required For improved garment care spin speed is restricted to 1000 rpm in this programme. In this programme default spin speed can be increased till 400 rpm. M0501 - tested and approved by The Woolmark Company - Whirlpool is a registered trademark of Whirlpool USA 5019 301 05765 Black process 45. 0° 100. 0 LPI 30105765GB. fm Page 2 Tuesday, June 28, 2005 6:15 PM CONSUMPTION DATA Programme Cotton Cotton Cotton with “Eco plus”*** Cotton Synthetics Synthetics Daily Superrapid Delicates Wool Handwash Temperature Selector (°C) 95 60 60 40 60 40 40 30 30 30 30 Load (kg) 6. 0 6. 0 6. 0 5. 0 2. 5 2. 5 3. 0 3. 0 1. 5 1. 0 1. 0 Water (l) 54** 49 49 44 55 55 45 37 60 60 45 Energy (kWh) 1. 90 1. 14 1. 02 0. 60 0. 80 0. 60 0. 50 0. 40 0. 50 0. 30 0. 30 Approx. Programme Duration (hours : minutes)* 2:00 2:20 2:30 2:05 1:30 1:20 1:00 0:30 0:45 0:40 0:40 • If you do not wish to spin the clothes, turn the programme selector knob counterclockwise to the “Drain” programme and press the “Start/Pause” button again when the indication next to it is flashing. “Spin Speed” button • Every programme has an automatic predefined maximum spin speed. • Press the button to set another spin speed. • If the spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start Delay” button to select the delay time by 1 to 23 hours; • Press the “Start/Pause” button. The indication next to the “Start Delay” button lights up and goes off when the programme starts. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Prewash cycle might increase programme duration. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter “Detergents and Additives” in the booklet. Turn the programme selector knob to the desired programme. [. . . ] When the combination of programme, additional options and temperature is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. “Easy Ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily” programmes to make ironing easier. • Increases the water quantity and the clothes are spun very soft. “Eco Plus” button • With a modified temperature profile and a slightly prolonged washing duration, the optimum combination of excellent washing result and even lower energy consumption can be achieved. [. . . ]