User manual WHIRLPOOL ARC 4004 IS PROGRAM CHART

[. . . ] • Temperature is selected by consecutive pressing of the button: - Minimum - Medium - Maximum • The appropriate of the green indicator lamps (under the asterisks) on the control panel is on. • The temperature of the freezer compartment is factory set at the medium position. The middle green indicator lamp on the control panel is on. • When the appliance is disconnected from power supply and then re-connected, the freezer remembers the previously set temperature. [. . . ] Light bulb of accessories may vary, depending on model. Notches for removing and door trays are removable. • The appliance accessories are not suitable for washing in Before replacing the light bulb, make sure to disconnect the a dishwasher. Following this: • Remove the fan cover by grasping the notches (3), bend The anti-bacterial filter ensures a higher level of hygiene in aside and pulling outwards. your refrigerator through continuous purifying of circulating • Remove the bulb by pulling it out (the bulb is of a special air from bacteria. Remove it from the box (found in the push-in type - do not rotate the bulb). crisper drawer (item 1) and insert into the grille (item D). • Check the bulb and replace it, if necessary, with a new one: Replace the filter every 6 months. Push the bulb into the fitting till it stops. Remove the filter together with the grille and dispose as a • Snap the cover back on. Replace the filter and the grille with the new ones. The replacement procedure is attached with the filter. • It is available via our After-Sales Service outlets only Our After-sales Service can supply this type of filter. GUIDE TO SELECTING FUNCTIONS Functions and settings Alarm off button Fast Freezing: Activate this function before freezing fresh products. To activate this function, press the “Fast Freezing” - All 3 green indicator lamps on the panel will light up simultaneously. This function is automatically disabled after 18 hours. To deactivate it earlier: - Press the “Fast Freezing” button again - the temperature selection indicator lamps will return to the previously set temperature level, or. - Press the temperature selection button in the freezer compartment. Temperature selection - It is possible to select between 3 levels of the freezer temperature (minimum, medium, maximum) by pressing the temperature selection button . The “Anti-Bacterial Filter” - alarm, signalled by the continuous yellow indicator lamp (2), indicates the need to replace the filter. After replacing the filter press the “RESET” button for approx. [. . . ] When the "RESET" is released, the indicator lamps will flash until the fault is eliminated. If any alarm from the table below occurs, other functions such as temperature adjustment and fast freezing are not available until the fault is eliminated. When several alarms occur simultaneously, the alarm with the highest priority is displayed. (Code 01 is the highest priority. ) Alarm priority Alarm code Temperature setting indicator lamps on minimum medium maximum MIN MED MAX Evaporator sensor failure Freezer sensor failure High freezer compartment temperature alarm Open door alarm 01 02 03 04 No Yes Yes Yes Yes No Yes Yes No No No Yes After determining the alarm code (between 01 and 04): • The user can eliminate the reason of the code 04 alarm by closing the door completely. • Code 03 alarm - The alarm deactivates when the minimum required temperature is reached. • The other alarms (code 01, 02) - Contact the After-Sales Service and provide the alarm code. [. . . ]