User manual WHIRLPOOL ARC 4138 INSTRUCTION FOR USE

[. . . ] Programme Duration (hours : minutes)* 2:10 2:10 2:20 2:05 4:00 1:35 1:20 1:30 0:50 1:00 0:30 0:45 0:40 0:36 Note: The programme stops to “Rinse hold” at the time the “Rinse hold” light in the programme sequence indication is on. The indication lamp next to the “Start/Pause” button flashes. Terminate the “Rinse hold” option: • Press the “Start/Pause” button; the programme will terminate automatically with the final spin cycle for the present wash programme. €¢ If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button. [. . . ] • Select programme , temperature and options. €¢ Press the “Start Delay” button to select the delay time by 1 to 23 hours; • Press the “Start/Pause” button. The indication light over the “Start Delay” button flashes and the countdown of the delay time begins. €¢ The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. €¢ Once having pressed the “Start/Pause” button, the number of hours preselected can be reduced by pressing again the “Start Delay” button. to cancel the “Start Delay” . Before you press the “Start/Pause” button: • Turn the programme selector to another position or press the “Reset” button. After having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 seconds - the start delay time disappears from the time display. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. Any existing water is drained out before the door can be opened. Whirlpool is a registered trademark of Whirlpool USA Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions * applicable at that time. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The time display shows the duration of the chosen programme (in hours and minutes), and the “Start/Pause” indication lamp flashes. The indication lamp of the predefined spin speed lights up. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lights up. [. . . ] Increases the cycle time by approximately 15 min. €¢ Do not use liquid detergent for the main wash when activating the “Prewash” option. “Cold wash” button • Water is heated only up to 20°C. €¢ Suitable for delicate laundry items with wash temperature recommendation of max. [. . . ]