User manual WHIRLPOOL ARC 8120/1/AL INSTRUCTION FOR USE

[. . . ] The replacement procedure is attached with the filter. Our After-sales Service can supply this type of filter. HOW TO OPERATE THE REFRIGERATOR COMPARTMENT Starting the appliance up • Insert the plug into the mains socket. • The appliance will switch on automatically unless knob (2) is set to position OFF. • The inside light switches on when both doors are opened. [. . . ] NOTE: Food products put inside the appliance before it achieved its set operating temperature may spoil. To adjust the internal temperature, if necessary: Turn the thermostat control knob (2): - Towards position MIN/1, if the temperature inside the compartment is too cold - Towards position MAX/7 for colder temperatures - To position OFF to switch the appliance off. Recommended thermostat position is MED/3-4. USING THE COOLING COMPARTMENT (depending on model) The appliance is equipped with a cooling compartment for storage of fresh food. To adjust temperature, if necessary, rotate the air regulator (4): • Towards position (+) for cooler temperatures • Towards position (-) for less cool temperatures. It is possible to remove the basket of the cooling compartment. A. Plastic "Dual" bottle holder (depending on model) 2. Cooling compartment (depending on model) 3. Antibacterial filter (depending on model) 9. Storage basket for frozen food items 12. How to proceed: • Remove the light cover or holder. • Remove the bulb pulling it out of the holder (do not rotate). • Check the bulb and replace (if necessary) by pushing its terminals into the holder sockets until it stops. • Replace the light cover or holder. The appliance is equipped with a special push-in light bulb These bulbs are available only from our After-sales Service. The bulb should not exceed 15W Do not leave uncovered light bulbs. Cleaning and Maintenance While cleaning, especially after removing the light cover, take special precautions and never touch the light bulb. Other abnormal appliance operations In case of abnormal appliance operation, a red alarm light will flash and a beep will sound. After pressing and holding the alarm deactivation "RESET" button, the beep will stop and the indicator lamps (Party Mode, Fast Cooling, Antibacterial Filter) will light up, allowing the user to determine the alarm code (in accordance with the following table listing possible alarm codes). When several alarms occur simultaneously, the alarm with the highest priority is displayed (the highest priority is alarm code 01). [. . . ] When the “RESET” button is released, the red indicator lamp will flash until the fault is eliminated. If the sensor failure alarm is displayed (alarm code 01), the Party Mode function is available until the fault is rectified. If the potentiometer failure alarm is displayed (alarm code 02), the Party Mode and Fast Cooling functions are available: Alarm types Alarm codes 01 02 03 Party Mode No No Yes Indicator lamp on Fast Antibacterial Cooling Filter No Yes Yes No No No CONTROL PANEL DESCRIPTION: 1 2 On/Off buttons 1. 7. 3 4 5 6 7 Alarm resetting button. [. . . ]