User manual WHIRLPOOL ARC4179 A NFW PRODUCT FICHE

[. . . ] Turntable with an ice-cube tray (depending on the model) 11. Ice-cube tray (depending on the model) 12. Super Fast Freezing (SFF) Compartment 13. The freezer door trays for pizza or other frozen products On/Off buttons with a short storage time (depending on the model) 1. [. . . ] Alarm deactivating button: “RESET”. Yellow indicator light informing of an alarm: “Black Out” and/or “Anti-Bacterial Filter” replacement. D) Anti-bacterial filter (depending on the model) 3. Green lamps indicating the “Freezer Temperature”. • The internal temperatures of the appliance depend on 5. Temperature selection button “-/+”. the ambient temperature, frequency of opening the doors, How to replace the bulb as well as location of the appliance. Adjust the thermostat knob depending on these factors. • The number and type of shelves, as well as configuration 2. Light bulb of accessories may vary, depending on model. After replacing the filter press the “RESET” button for approx. 5 seconds until the indicator lamp goes off. “Black-out” Alarm - in case of power failure, the appliance automatically monitors the temperature changes in the freezer compartment. After the power supply returns, - the “Black-out” alarm will activate, if the temperature has risen above the admissible level. This is indicated by: - Flashing of the yellow indicator lamp (2). When the “Black-out” alarm is active, it is recommended to proceed as follows: - If the food in the freezer is not frozen but is still cold, transfer it promptly to the refrigerator compartment and consume within 24 hours. - If the food in the freezer is frozen, it has re-frozen after thawing caused by the power failure. Consumption of re-frozen food is not recommended since it lost its nutritive value and may be hazardous to your health. Note: The “Black-out” alarm does not guarantee the food quality and its safety in case of consumption. It merely indicates the necessity to assess the quality of food in the freezer andrefrigerator compartments. [. . . ] It merely indicates the necessity to assess the quality of food in the freezer andrefrigerator compartments. To deactivate the alarm, press the “RESET” button for approximately 3 seconds, until the indicator light goes off. The temperature will return to the normal operating cycle level and the beep will silence. Other abnormal appliance operations displayed by indicator lamps. In case of abnormal appliance operation, all the temperature selection indicator lamps will flash and a beep will sound. After pressing and holding the alarm deactivation "RESET" button, the beep will stop and the indicator lamps will light up, allowing for determining the alarm code (in accordance with the following table listing possible alarm codes). [. . . ]