User manual WHIRLPOOL ARC7593/1 PROGRAM CHART

[. . . ] To turn the refrigerator back to setting point repeat this procedure. Important: after activating this function, remove all perishable foodstuffs from the refrigerator compartment and leave the door closed, since the refrigerator maintains a suitable temperature to prevent the formation of unpleasant odours. Plastic “Dual” shelf (depending on the model) 2. Cooler compartment (depending on the model) 4. [. . . ] Our After-sales Service can supply this type of filter. To adjust the internal temperature (if necessary): Turn the thermostat control knob (2): - Towards position 1 if the temperature inside the compartment is too cold. - Towards position 7 for colder temperatures. - To position OFF to switch the appliance off. Recommended thermostat position: 3-4. USING THE COOLER COMPARTMENT (depending on the model) The appliance is equipped with a cooler compartment. To adjust temperature (if necessary), rotate the air regulator (4): • Towards position (+) for cooler temperatures. • Towards position (-) for less cool temperatures. It is possible to remove the basket of the Cooler compartment. USING THE FREEZER COMPARTMENT • The freezer compartment starts operation as soon as the appliance is plugged into the power outlet socket. Attention: • There is no need to adjust the thermostat knob as the temperature is factory set to ensure the correct storage temperature for fresh foods at ambient temperatures between +20°C and +25°C. • After switching on, the freezer compartment takes approximately 3 hours to reach a suitable temperature for frozen food storage. To adjust the internal temperature (if necessary): Turn the thermostat control knob (1): - Towards position 1 for less cold internal temperatures. - Towards position 3 for colder temperatures. - To position to use the fast freeze function. 24 hours before freezing fresh food, turn the knob (1) to position ; When turning from 3 to pos. , the knob is slightly stiff and the yellow indicator (3) near the symbol lights up. Place food in the drawer, leaving enough space for air to circulate around packs. For more efficient freezing, turn the knob (2) to position 7. Leave the fast freeze function activated for the next 24 hours 5. When freezing is complete, turn both knobs (1), (2) back to their recommended positions. Other abnormal appliance operations In case of abnormal appliance operation, a red alarm light will flash and a beep will sound. After pressing and holding the alarm deactivation “RESET” button, the beep will stop and the indicator lamps (Party Mode, Fast Cooling, Antibacterial Filter) will light up, allowing the user to determine the alarm code (in accordance with the following table listing possible alarm codes). When several alarms occur simultaneously, the alarm with the highest priority is displayed (the highest priority is alarm code 01). When the “RESET” button is released, the red indicator lamp will flash until the fault is eliminated. If the sensor failure alarm is displayed (alarm code 01), the Party Mode function is available until the fault is rectified. If the potentiometer failure alarm is displayed (alarm code 02), the Party Mode and Fast Cooling functions are available. [. . . ] When it is necessary to replace the filter, a yellow LED (6) lights up. After replacing the filter, press and hold for 3 seconds the Reset filter button (7) to deactivate the alarm. Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. [. . . ]