User manual WHIRLPOOL ARF 192/R/WP INSTRUCTION FOR USE

[. . . ] This appliance conforms to EEC directive 87/308 on radio-interference. Information This appliance is free of HCFC’s (refrigerant circuit contains R 34 a) or free of HFC’s (refrigerant circuit contains R 600 a - Isobutane). For more details, please refer to the rating plate on the appliance. For appliance with Isobutane (R 600 a) The refrigerant Isobutane is a natural gas of high environmental compatibility but which is inflammable. Therefore, it is essential to ensure that the ducts of the refrigerant circuit do not get damaged. Conformity declaration x x HOW TO OPERATE YOUR REFRIGERATOR 1. Turn the thermostat control knob clockwise to the desired position (higher numbers to get colder temperature). How to store food 1. [. . . ] Check that the defrost tray is still under the ice compartment. Turn the thermostat control knob to position defrost. When the ice has melted completely, empty the water from the defrost tray. Turn back the thermostat control knob to the desired setting. Quick defrosting This function is used to defrost your refrigerator more quickly. Disconnect the appliance from the mains. 50oC) under the ice compartment and leave the refrigerator door open (this will speed up the defrost process). Clean the inside with a sponge dampened in a solution of warm water and neutral detergent. Connect the appliance to the mains and put back all items into the refrigerator. x x 4 X Wipe the outside with a soft cloth dampened in water. Periodically clean the condenser (radiator) situated at the rear of the refrigerator with a vacuum cleaner or a brush. For prolonged absences 1. Leave the door open to prevent any bad odour. 10 M 10 Y N C TROUBLE SHOOTING GUIDE 1. The temperature in the compartment is not cold enough x Is the door properly closed ?The earthing of the refrigerator is compulsory by law. The Manufacturer will accept no liability for damage to persons or to objects arising from the non-observance of this requirement. If the plug and the wall socket do not comply, have the socket replaced by a qualified technician. Do not use adapters, multipole sockets or extension cords. 2 X Door reversibility 1 X. 8. Tilt the appliance backwards and remove the lower right hinge. Remove the door from the pin of the top hinge. Remove the screw cover, the screws and the top right hinge. Remove the 3 clips covering the holes of the left screws. Fix the hinge to the top left hand side, using the same screws to tighten it. Reposition the clips and the screws cover in the new relevant holes. Fit the door in the pin of the top hinge. [. . . ] If the mains lead of this appliance is fitted with a BS 1363A 13 amp fused plug, to change a fuse in this type of plug use an A. S. T. A. approved fuse to BS 1362 type and proceed as follows: A suitable altenative plug should then be fitted to the cable. The wires in this mains lead are coloured in accordance with the following code; BLUE - “NEUTRAL” (“N”) BROWN - “LIVE” (“L”) GREEN AND YELLOW - “EARTH” (“E”) 1. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol 4 or coloured green or green and yellow. [. . . ]