User manual WHIRLPOOL ARF 220/A PRODUCT FICHE

[. . . ] Programme recommended when using detergents of type B (enzyme-based detergents). Programme recommended when using detergents of type A (non enzyme-based detergents). 5019 100 91213 (We reserve the right to make technical modifications) How to use the dishwasher 1. After loading the dishwasher, close the door properly and open the water supply tap. [. . . ] To change the selected programme, press the Start button for about 5 seconds. the Start indicator lamp will switch off. Select a new programme using the programme selector knob and press the Start button. Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) switches on (for about 30 min). Turn the programme selector knob to the “0” position to switch off the dishwasher (only after the Start indicator lamp has switched off). Unload the lower rack before the upper one. €¢ • • Upper and lower rack To raise: pull up the two side handles until the rack clicks into place. Lower rack A A Crockery holders: • Upper rack C Half load / Haute pression: “Flex 3”: multi-purpose support To be used, for example, for longhandled utensils (arrange knives with the blade facing downwards), cups and glasses. €¢ May be used in three different positions (see also “Dishwasher loading instructions” on Page 4). €¢ Have you selected the correct programme?€¢ Did you use too much or too little detergent?(The use of poor quality detergents may result in less effective washing). €¢ Are the spray arms blocked or the nozzles clogged?Marked crockery: • Is the water hardness level selector not properly adjusted?(See “Filling the salt container” in the user instructions). • Is the salt container empty?(See “Filling the salt container” in the user instructions). • Was insufficient detergent used?(See “Filling the detergent dispenser” in the user instructions). Marked glasses and cutlery: • Was too much rinse aid used? [. . . ] €¢ If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. €¢ If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). €¢ Sometimes even though the regeneration salt container has been filled, the corresponding indicator lamp (if fitted) will light up during the first wash cycle after filling with salt. If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket? [. . . ]