User manual WHIRLPOOL ARL 620/G/NI GEBRUIKSAANWIJZING

[. . . ] On releasing the button this is confirmed by an acoustic signal. Reset button Load the upper or lower rack only. This function can be used with any programme. [. . . ] For dosage of powder detergent in compartment A and B refer to the programmes table. Select, save, and supply the detergent Check the rinse aid level Check the regeneration salt level Load the racks Close the dishwasher door, turn on the water tap Select a programme The last programme selected will light up. Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up. The corresponding indicator lamp lights up. €œChange programme in progress” Select additional options Press the Start button The selected programme is then memorised (even in the event of power failure). until the Start indicator lamp switches off. Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Only after the START button has switched off: Press the ON / OFF button. Warning: When the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided depending on the model Upper rack: Crockery holder (A): Depending on the position, for long-handles utensils, cups and plates. Carving forks, knives) must be arranged with the sharp end facing in towards the appliance. b A C D Half Load: Load the upper rack (see description of Options). [. . . ] €¢ Depending on the material, if necessary use a detergent with a greater whitening power. Opaque glasses/ glasses • Cannot be washed in the dishwasher. Not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. [. . . ]