User manual WHIRLPOOL ART 364/A /6 INSTRUCTION FOR USE

[. . . ] The fan must also be switched on for it to work properly. The function can be deactivated/reactivated (see Fan description). To deactivate the fan, press the "Freezer °C" and "Fridge °C" buttons together for 3 seconds. When the 6th Sense Fresh Control indicator is off, the fan is switched off and therefore the 6th Sense Fresh Control is deactivated. [. . . ] If the ambient temperature exceeds 27°C, the fan must be on in order to ensure the proper preservation of foods. Deactivation of the fan allows energy consumption to be optimised. Vacation (Vacation Mode) This function can be used during a prolonged absence. Press the "Fridge C°" button for 3 seconds to activate/deactivate the function. The display shows the refrigerator compartment temperature (+12°C). After activating the function, remove the food from the refrigerator compartment and keep both doors closed: the refrigerator will maintain a suitable temperature to prevent odours. The freezer remains switched on. Stop Cooling Press for 3 seconds to activate/deactivate appliance cooling. The indicator lights up in Stop Cooling mode. Notes: This operation will not disconnect the appliance from the power supply. This function does not deactivate the inside light, which can be switched off by pressing the button on the base of the fan. Switching off acoustic alarms To deactivate acoustic alarms, press the "Reset Alarm" button. Key Lock The key lock can be activated/deactivated by keeping the "Reset Alarm" button pressed for 3 seconds, until a confirmation beep sounds: "LO" will appear on the display for a few seconds. Blackout Alarm (where provided) This alarm activates when there has been an extended power failure causing the freezer compartment temperature to rise. The value flashing on the freezer display is the highest temperature reached during the power failure. Antibacterial and anti-odour filter exhausted (if installed). Replace the antibacterial filter. Press the mute acoustic alarm button to switch off the sound signal. The red indicator lamp goes off automatically when an optimal temperature has been reached. If the temperature alarm persists, contact an authorized After-Sales Service. The red indicator lamp is flashing, there are letters on the single display, and a buzzer is sounding (if not previously disabled). A buzzer sounds, and the freezer temperature display and the red indicator lamp (if installed) flash. Call an authorized After-Sales Service. Press the mute acoustic alarm button to switch off the sound signal. Press the mute alarm button to switch off the acoustic signal. Check the state of foodstuffs before consuming them. Read the instructions carefully before using the appliance. Features, technical data and images may vary according to the model. A buzzer sounds. [. . . ] The red indicator lamp flashes or the letters "AF" appear on the display (depending on the model). After replacing the filter, press and hold the mute alarm button for at least three seconds: The red indicator lamp will go off. D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO 5019 308 01036 Printed in Italy 01/11 - Whirlpool is a registered trademark of Whirlpool, USA - © Copyright Whirlpool Europe s. r. l. All rights reserved - http://www. whirlpool. eu Refrigerator Compartment A. Fan and anti-bacterial and anti-odour filter (depending on model) B. Bulb or LED light (depending on the model) C. [. . . ]