User manual WHIRLPOOL ART 471/3-LH PROGRAM CHART

[. . . ] Note: This operation will not disconnect the appliance from the power supply. Temperature or Malfunction Alarm See table below. Fast Freezing (Extra Load) To be activated 24 hours before large quantities of food to be frozen are placed in the freezer compartment. The function disables automatically after 48 hours or can be switched off manually by pressing the button again. [. . . ] Key Lock The child lock can be enabled/disabled by pressing and holding the + and - keys near the child lock key for three seconds until a beep sounds to confirm your selection. If a key is pressed while the child lock is enabled, a beep sounds and "CL" or "LO" appear for a few seconds on the freezer compartment temperature display. GB Antibacterial/anti-odour filter exhausted (if installed). Switching off acoustic alarms. Freezer compartment temperature The display will show the freezer compartment temperature. A different temperature can be set using the + and - keys beside the display. Fan and anti-bacterial and anti-odour filter (depending on the model) B. Internal light (depending on the model) C. Rating plate (at the side of crisper drawer) H. Door trays P Bottle holder (if provided) . Bottle bin Least cold zone Intermediate temperature zone Coldest zone Crisper zone Freezer Compartment I. Middle and lower baskets (storage area for frozen and deep-frozen food) M. is not working (or blinks) and an acoustic signal sounds (if not This activates when the refrigerator door is left open at length. If the control panel is fitted with 2 displays, check that it is not a refrigerator door open alarm (see previous line). In all other cases, you may need to replace the light. It is not cold enough inside the compartments. There could be various causes (see "Solutions" column). Water collects at the bottom of the refrigerator compartment. The front edge of the appliance near where the door seal strikes is warm. It is a design feature to prevent condensation from forming. The control panel won't do anything: every time a key is pressed, The "Key Lock" "CL" or "LO" appear on the display. function has been enabled. Disable the "Key Lock" function as explained in the Quick Start Guide. Freezer compartment temperature alarm and a beep will sound The temperature alarm indicates that the temperature in the compartment is not ideal. This can happen: When it is first used after defrosting and/or cleaning, when freezing large quantities of food or when the freezer door doesn't close properly. Press the "Acoustic alarm mute" button to switch off the acoustic signal. The red LED goes off automatically when an optimal temperature has been reached. If the temperature alarm persists, contact an authorized After-Sales Service. Malfunction Alarm The red indicator lamp is flashing, there are letters on the display, and a buzzer is sounding (if not previously disabled). The alarm indicates that a technical component has malfunctioned. [. . . ] If the temperature alarm persists, contact an authorized After-Sales Service. Malfunction Alarm The red indicator lamp is flashing, there are letters on the display, and a buzzer is sounding (if not previously disabled). The alarm indicates that a technical component has malfunctioned. Blackout Alarm (where provided) This alarm activates when there has been an extended power failure causing the freezer compartment temperature to rise. The value flashing on the freezer display is the highest temperature reached during the power failure. [. . . ]