User manual WHIRLPOOL ART 471/A/3 INSTRUCTION FOR USE

[. . . ] Only woollens, labelled with the Woolmark and identified as machine washable. This programme (40°C) is tested and approved by The Woolmark Company for machine washable wool. textiles made of linen , silk , wool and viscose marked as “handwashable”. This programme (40°C) is tested and approved by The Woolmark Company for handwashable wool. [. . . ] Same as the last rinse and the final spin in the “Cotton” programme. in this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Water is drained only without any spinning. €œReset” button Detergents and additives Prewash Main wash Softener Special options Half load Spin speed reduction 500rpm Programme Care Labels Spin Speed rpm 95 °C 6. 0 — — — — — — — — — ❉: 1) 2) optional / Yes : dosing required For improved garment care, spin speed is restricted in these programmes. Do not use liquid dergent for the main wash. The wool and handwash cycles of this machine have been tested and approved by The Woolmark Company for the washing of Woolmark garments labelled as “machine wash” or “hand wash” provided that the garments are washed according to the instructions on the garment label and those issued in this programme chart. Programme Duration (hours : minutes)* 2:00 2:20 2:00 1:30 1:15 0:45 0:30 0:45 0:40 0:36 PROGRAMME START Open the tap and press the “Start (Pause)” button. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. cANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. €¢ Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions * applicable at that time. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference Programme for Energy Label. [. . . ] ** *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in your Instructions for Use. Close the door and turn the programme selector to the desired programme and temperature. The indication lamp next to the “Start (Pause)” button flashes. [. . . ]