User manual WHIRLPOOL ASE 021 INSTRUCTION FOR USE

[. . . ] Read the instructions contained in this manual very carefully, as they are very important for safety in case of installation, use and maintenance. 1. The appliance must be used only for its intended purpose, i. e. for holding previously chilled food or drinks; the appliance is not designed for any other use that is therefore prohibited. [. . . ] In case of replacement use a H05 RN-F3X1. 5 sq. mm cord. It must be fitted into the cable fastener and locked. Each wire must be fixed to the relevant terminal; the earth wire must be longer than the other wires so that if pulled the latter is disconnected only after the power wires. Safety is guaranteed only when the appliance has proper grounding as currently prescribed. The appliance must be included in the equipotential system. The screw is on the lower part of the right side (serving side) and it is marked by the symbol : 7) CONDENSATION WATER DRAINING Water is drained by falling on special basins fitted on runners underneath. Water can be drained directly into a trap (see installation diagrams for correct positioning). 5 8) GENERAL INSTRUCTIONS FOR USE Read the instructions contained in this paragraph very carefully; they contain general instructions concerning safety, operation and maintenance of the appliance. The appliance has already been submitted to a strict control by qualified personnel at the end of the process. Any repairs that may become necessary in time should be carried out only by qualified personnel. We suggest to apply always to the dealer where the unit has been purchased and possibly with the most precise information concerning the inconvenience and the data plate features. This information will help the service centre. At the end of every day, clean the unit thoroughly (see page 10). This guarantees the long life of the appliance. At the end of daily use, remember to switch off the appliance and disconnect power supply to it. When equipped with wheels, 2 of the 4 will be lockable. If the equipment has to be moved, switch it off before performing this operation and disconnect power supply. Non-compliance with these instructions may affect the safety of the appliance and of the user. The manufacturer declines any responsibility in case the original functionality of the appliance has been affected because of non-compliance with instructions or when devices have been added or changed. 9) CLEANING AND CARE Warning: when cleaning the appliance, do not wash it with a direct or pressurised jet. [. . . ] After changing, release key “SET” . 7 11) USE AND OPERATION 1. Switch the appliance on (ON/OFF switch). The appliance takes one hour to reach operating temperature. 3. To ensure that the food and/or drinks are always kept at the right temperature, it is advisable to set the thermostats at a temperature of respectively -0/+2°C (Thermostat Top/tank) 0/+6°C (Thermostat cell) und +5/10°C (Thermostat display counter) 4. In the refrigerated display counter make sure to avoid obstructing the ventilation areas (suction/flowing) to ensure that cold air circulates properly. [. . . ]