User manual WHIRLPOOL AVM 230 INSTRUCTION FOR USE

[. . . ] Especially suitable for pans and saucepans. Light soiling, especially glasses and cups. : different loads, water temperatures (above or below 15° C), water hardness and power supply voltage, etc. reference programme for Test Institute and energy-label. [. . . ] This information remains in the memory even during interruption of the power supply. To change the selected programme, press the Start button for about 5 seconds. the Start indicator lamp will switch off. Select a new programme and press the Start button. Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for about 30 min. Once the Start indicator lamp has switched off, turn the programme selector knob to the initial position to switch off the dishwasher. Unload the lower rack before the upper one. €¢ • • Upper and lower rack To raise: pull up the two side handles until the rack clicks into place. Lower rack A A C Half load / Multizone: Loading the lower rack only gives greater washing power, especially for plates and saucepans. €¢ Have you selected the correct programme?€¢ Did you use too much or too little detergent?(The use of poor quality detergents may result in less effective washing). €¢ Are the spray arms blocked or the nozzles clogged?Marked crockery: • Is the water hardness level selector not properly adjusted?(See “Filling the salt container” in the user instructions). • Is the salt container empty?(See “Filling the salt container” in the user instructions). • Was too little detergent used?(See “Filling the detergent dispenser” in the user instructions). Marked glasses and cutlery: • Was too much rinse aid used? [. . . ] €¢ If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. €¢ If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). €¢ Sometimes, even though the regeneration salt container has been filled, the corresponding indicator lamp (if fitted) will light up during the first wash cycle after filling with salt. If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket? [. . . ]