User manual WHIRLPOOL AVM 404/1 WP WH INSTRUCTION FOR USE

[. . . ] The burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of a sudden draught, an interruption in the gas delivery, boiling over of liquids, etc. — • At the same time, hold the knob down until the burner ignites. [. . . ] — • At the same time, hold the knob down until the burner ignites. • After the burner has ignited, keep the knob pressed for about 10 seconds. If the burner does not ignite, repeat the operation. 1 Note: In case of installation of a hood above the cooking hob, please refer to the hood instructions for the correct distance. important: Installation of this product requires masonry and/or carpentry work. Then place the hob on the milled surface and secure it to the support structure using screws and brackets “C” or “D” (depending on the thickness of the worktop), until it is flush to the worktop. Brackets “C” should be used to secure the hob to a top which is 20 to 30 mm thick, whereas brackets “D” should be used for a worktop 30 to 50 mm thick. Important: • tighten the brackets that secure the hob to the worktop by hand. • if the worktop is made of wood or similar materials, the milled surface must be protected with primer (protective paint) before applying seal E. Fm Page 3 Wednesday, March 17, 2004 12:37 PM INJECTORS TABLE Type of gas used Type of burner Triple crown semi-rapid auxiliary Triple crown semi-rapid auxiliary Triple crown semi-rapid auxiliary Injector marking 133 97 72 94 65 50 94 65 50 Rated heat Rated capacity consumption Pcs-kW 3. [. . . ] Important: • tighten the brackets that secure the hob to the worktop by hand. • if the worktop is made of wood or similar materials, the milled surface must be protected with primer (protective paint) before applying seal E. [. . . ]