User manual WHIRLPOOL AVM 950 IX INSTRUCTION FOR USE

[. . . ] in this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. 5 Yes — — — — — — — — — — — — — — — — — — — — — 0 2) 1400 1400 800 1) h — — — h — — — — — h: 1) 2) optional / Yes : dosing required For improved garment care spin speed is restricted to 800 rpm in this programme. [. . . ] For improved garment care spin speed is null in this programme. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergent as described in the programme table or in the chapter “Detergents and Additives” in the booklet. Turn the programme selector knob to the desired programme and temperature. The remaining time display shows the duration of the chosen programme (in hours and minutes) and after taking some seconds for calculating, the indication of the “Start/Pause” button is flashing. The programme sequence and the predefined spin speed indication corresponding to the selected programme lights up. SELECT ANY DESIRED OPTION Selecting any option the indication lights up. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication next to the “Start/Pause” button lights up. The indications show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding indication goes out. rED INDICATIONS “Water Tap Closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean Pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). €œDoor Locked” As long as a washing programme is running, the lamp lights up to show that the door cannot be opened. [. . . ] €œDoor Locked” As long as a washing programme is running, the lamp lights up to show that the door cannot be opened. When the indication goes off, the door can be opened again. PROGRAMME END • The remaining time is on “0:00” and all the lights of the programme sequence indication are off. Turn the programme selector to the “Off/0” position. [. . . ]