User manual WHIRLPOOL AWA 9127 PROGRAM CHART

[. . . ] load kg End Appears in display when programme is ended and drum opening is in position. Programme Care Labels Type of wash / Notes Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. For heavily soiled laundry the additional “Prewash” option can be selected as well. Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. [. . . ] **To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water ou. t Note: The programme with “Rinse Hold” stops when the “Rinse Hold” is indicated in the display. Appliance in “Rinse Hold”: • If you want to continue the programme press the “Start/Pause” button again: The programme will terminate automatically with the selected spin cycle. If the load is dry then please press the “Start/Pause” button. • If you do not wish to spin the load, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button. “Spin Speed Reduction” button • Every programme has an automatically allocated maximum spin speed. • Press the button until you have reached the requested spin speed indicated in the display. • If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. START DELAY The “Start Delay” button allows the user to run the appliance at his convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start Delay” button several times to select the delay time by 1 to 24 hours (selected delay is indicated in display); • Press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up, the lamp of the “Start Delay” button flashes and the selected delay is indicated in the display. • The time delay indication disappears when the programme starts and is replaced by the remaining time. • The number of hours preselected can be reduced later by pressing the “Start Delay” button again. To cancel the pre-selected “Start Delay” • Turn the programme selector to the “ ” position. • Reselect the desired programme and options and press the “Start/Pause” button. PROGRAMME START Open the tap and press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up. At programme start the sequences reached by the programme are indicated in the display. Note: If there's a power cut during the cycle, the programme will continue automatically from where it was interrupted. LID LOCK For safety reasons, the lid is locked during certain phases of the cycle. At the end of the cycle or during an interruption, the lid unlocks automatically after about 1 minute. END OF WASH CYCLE • Upon programme end “ ” is shown in the display. [. . . ] The temperature ( and spin speed can be changed by pressing the corresponding button. SELECT THE DESIRED OPTION When you select an option authorized by the programme, the corresponding indicator lights up, except if the combination of programme, additional options and temperature is not possible. “Easy Ironing” button • Can be used together with “Cotton”, “Synthetic” and “Daily Mixed” programmes to make ironing easier. • Increases the water quantity in rinsing and the clothes are spun in a softer manner. “Prewash” button • Only for heavily soiled loads (for example mud, granular dirt). [. . . ]