User manual WHIRLPOOL AWC 5081 PRODUCT FICHE

[. . . ] Do not expose the appliance to atmospheric agents. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the attention symbol and the following terms: DANGER: indicates a hazardous situation which, if not avoided, will cause serious injury. [. . . ] If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, a qualified electrician should install a standardised double pole ENGLISH 6 power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with wiring rules. Use The hood has been designed to be installed and used either as a “Exhausted model”, or as a “Recirculation model”. Exhausted model (see symbol in installation booklet) Cooking steam is sucked and channelled outside the house through a discharge duct (not supplied), fitted to the hood steam outlet. Ensure that the discharge duct is correctly fitted to the air outlet, unit using an appropriate connection system. Important: If already installed, remove the charcoal filter/s. In Recirculation model (see symbol installation booklet) The air is filtered through one or more the charcoal filters, and then resent into room. important: Ensure appropriate air circulation around the hood. Important: If the hood is supplied without charcoal filters, these must be ordered and fitted before the hood can be used. The hood should be installed away from particularly dirty areas, windows, doors and heat sources. The hood is sold with all necessary components for installation on most types of walls or ceilings. Fit the filter/s over the motor according to the model: • align the pins on the cowl with the slots, then turn the filter clockwise until it locks in place. Reverse the above procedure to remove the charcoal filter. Problem The appliance does not work Possible cause There is no mains electrical power Solution Check for the presence of mains electrical power. Turn off the appliance and restart it to see if the faults persists. Check if the appliance is connected to the electrical supply. Turn off the appliance and restart it to see if the faults persists. Check the suction speed and adjust as necessary. Check that the filters are clean If not, clean the filters in the dishwasher. Check the air vents for any obstructions and remove as necessary. If not, fit the light bulb in right way. The appliance is not connected to the electrical supply The hood’s suction level is not enough The suction speed is too low The metal filters are dirty The air vents are obstructed The light does not work The light bulb is broken The light bulb is not correctly fitted Before contacting the After-sales service: Switch the appliance on again to see if the problem has disappeared. [. . . ] This guarantee applies to domestic use only. The exceptions are specified under the headline “What is not covered under this guarantee?€ Within the guarantee period, the costs to remedy the fault e. Repairs, parts, labour and travel will be covered, provided that the appliance is accessible for repair without special expenditure. [. . . ]