User manual WHIRLPOOL AWE 2117

[. . . ] · Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. 5. Drain · Connect the drain hose to the siphon or hook it over the edge of a sink by means of the "U" bend supplied. · If the washing machine is connected to an integrated drainage system, ensure the latter is equipped with a vent to avoid simultaneous loading and draining of water (siphoning effect). 6. Electrical connection · Electrical connections must be carried out by a qualified technician in compliance with the manufacturer's instructions and current standard safety regulations. · Data regarding voltage, power consumption and protection requirements is given on the inside of the door. · The appliance must be connected to the mains by means of a socket with an earth connection in accordance with current regulations. [. . . ] Never put both chlorine bleach and softener into the softener chamber at the same time. A Separator ( ) Separator Hooks A B 2 3 Guide Rails How to position the separator in the main wash chamber for powder or liquid detergent For use with powder detergent: place the separator in the higher position. Lift the separator until its top can be reclined. Place its hooks on the upper end of the back guide rails and slightly push the separator down to fix it (fig. A gap should remain between the separator and the bottom of the main wash chamber, if the separator has been correctly installed (fig. For use with liquid detergent: place the separator in the lower position. Secure the separator in the chamber using the front guide rails. Position the separator so that it touches the bottom of the main wash chamber (fig. "D"). 1 C 1 D 23 Notes: · Keep detergents and additives in a safe, dry place out of the reach of children. · Liquid detergents can be used for programmes with prewash. However, in this case a powder detergent must be used for the main wash. · Do not use liquid detergents when activating the "Start Delay" function (if available on your washing machine). For washing machines with an inlet hose as shown on pictures "A", "B" or "C" (depending on the model): 1. Close the tap and loosen the inlet hose on the tap. Clean the internal mesh filter and screw the water inlet hose back onto the tap. Now unscrew the inlet hose on the rear of the washing machine. Pull off the mesh filter from the washing machine connection with universal pliers and clean it. Refit the mesh filter and screw the inlet hose on again. Turn on the tap and ensure that the connections are completely water-tight. B C 27 TROUBLESHOOTING GUIDE Depending on the model, your washing machine is equipped with various automatic safety functions. This enables faults to be detected in good time and the safety system can react appropriately. These faults are frequently so minor that they can be removed within a few minutes. The washing machine will not start, no indicator lamps are on. Check whether: · the mains plug is inserted into the socket; · the wall socket is functioning correctly (use a table lamp or similar appliance to test it). [. . . ] Select and start the "Rinse & Spin" programme. Afterwards, select and start the desired programme again, using less detergent. If the fault persists, unplug the appliance and contact our After Sales Service. 29 AFTER-SALES SERVICE Before contacting After-Sales Service: 1. Try to remedy the problem yourself (see "Troubleshooting Guide"). [. . . ]