User manual WHIRLPOOL AWE 2219 PRODUCT FICHE

[. . . ] A very gentle spin is used in Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. 5. 5 Offers highest economy in energy consumption by prolonged wash duration. Ideal to be run overnight to additionally profit from the more favourable energy rates. To avoid noise of spinning at night, set spin speed to “0” and start spin programme in the morning, or define programme start with “Start Delay” accordingly. [. . . ] • Select programme, spin speed and options. • Press the “Start Delay” button several times to select a delay time by 1 to 23 hours. • Start the programme (see “Progremme Start”). The indication lamp over the “Start delay” button lights up and goes off when the programme starts. • Once having pressed the “Start/Pause” button, the countdown of the time delay begins. The time delay indication on the display disappears when the programme starts and is replaced by the remaining time. • After the “Start/Pause” button has been pressed, the number of hours preselected can be reduced by pressing again the “Start delay” button. To cancel the “Start delay” . . before you press the “Start/Pause” button: • Turn the programme selector to another position or press the “Reset” button. . . after having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 second. The start delay indicator light goes off. PROGRAMME START Open the tap and press the “Start/Pause” button. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Prewash cycle increases programme duration by aproximately 20 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. *** The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions applicable at that time. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. Add detergent and additives into the dispenser to no more than the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Stain remover agents • Anti-scale agents (if necessary) 3. Turn the programme selector to the desired programme and temperature. [. . . ] • Selectable for programmes Cotton 95°C and Synthetics 60°C only. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. Increases the cycle time by approximately 20 min. “Intensive Rinse” button • The amount of water is increased to ensure a more intensive rinse. • This option is particularly suitable for areas with very soft water, washing baby linen and people with skin allergies. [. . . ]