User manual WHIRLPOOL AWE 5200 PRODUCT FICHE

[. . . ] Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. [. . . ] Alternative method of terminating programme after “Rinse Hold”. – Yes Yes 1) i i i 600 2. 5 Yes i i i 600 2. 5 – Yes i i i 600 1. 5 3. 0 1. 0 1. 0 5. 0 5. 0 1. 0 – – – – – – – – – Yes Yes Yes Yes – – – – i i i i i – – – – i – – i – – – i i i i i – – – 600 600 600 400 2) 600 600 600 – N. B. Please avoid excessive detergent dosing. Whirlpool is a registered trademark of Whirlpool USA. 5019 312 10513 CONSUMPTION DATA Temperature Programme (°C) Cotton Cotton** Cotton Synthetics Synthetics Delicates Quick wash Wool Handwash 95 60 40 60 40 40 30 40 40 (kg) 5. 0 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 1. 0 1. 0 (l) 50* 55 55 50* 45 50 35 55 40 (kWh) 1. 70 0. 95 0. 55 0. 80 0. 45 0. 55 0. 40 0. 55 0. 40 Load Water Energy Approx. Programme Duration (hours : minutes) 2:05 2:10 2:00 1:30 1:15 0:45 0:30 0:45 0:35 PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. • Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. Add detergent and additives into the dispenser to no more than the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Stain remover agents • Anti-scale agents (if necessary) 3. Turn the programme selector to the desired programme and temperature. The lamp next to the “Start/Pause” button flashes. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. [. . . ] The lamp next to the “Start/Pause” button flashes. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. “Intensive rinse” button • The amount of water is increased to ensure a more intensive rinse. • This option is particularly suitable for areas with very soft water, washing baby linen and people with skin allergies. [. . . ]