User manual WHIRLPOOL AWE 6419P PRODUCT FICHE

[. . . ] In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Alternative method of terminating programme after “Rinse Hold”. – – – – – – – Yes Yes Yes – – – – i – – – – – – – i – – i – – – i i 1000 1000 400 2) 1000 1000 1000 – i i i i i – – – i i – – – i i i i – N. B. [. . . ] Programme Duration (hours : minutes) 2:05 2:10 2:00 1:30 1:15 0:45 1:00 0:30 0:45 0:35 PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. • Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your “Instructions for Use”; if the fault persists, contact our After Sales Service. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. Add detergent and additives into the dispenser to no more than the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Stain remover agents • Anti-scale agents (if necessary) 3. Turn the programme selector to the desired programme and temperature. The lamp next to the “Start/Pause” button flashes. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. Increases the cycle time by approximately 20 min. [. . . ] Increases the cycle time by approximately 20 min. “Intensive rinse” button • The amount of water is increased to ensure a more intensive rinse. • This option is particularly suitable for areas with very soft water, washing baby linen and people with skin allergies. “Rinse hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the “Synthetics”, “Daily load” and “Delicates” programmes. [. . . ]