User manual WHIRLPOOL AWE 6510 PRODUCT FICHE

[. . . ] Normally soiled cotton jeanswear and garments made of jeanslike material such as trousers and jackets. In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the last rinse and the final spin in the “Cotton” programme. [. . . ] *** Reference Programme for Energy Label. SAVE YOUR FAVOURITE PROGRAMMES If there is a programme setting which you use frequently, the appliance offers the possibility to save one setting for each programme so that it can be used again by just pushing one button. • Select the desired programme, temperature, spin speed and option(s), push and hold the “Favourites” button for at least 3 seconds. The lamp next to “Favourites” shortly flashes and then lights up - the programme settings is saved. Next time you want to use your individual programme settings, select the programme, push the “Favourites” button and start by pushing “Sart/Pause”. If you want to replace the saved programme setting by another one: • Push the programme button, select temperature, spin speed and options as desired and then press and hold the “Favourites” button for at least 3 seconds. The previously saved programme setting will be replaced by the new one. START DELAY The “Start delay” allows to run the machine at the consumer's convenience, for example at night when electricity is cheaper. • Select programme, temperature, spin speed and options. • Press the “Start Delay” button to select the delay time up to 23 hours. • Press the “Start/Pause” button. The countdown of the delay time begins; the clock symbol next to the delay time and the dot between hours and minutes flash. Switch the machine off by pressing “On/Off”. Open lid and drum and unload the machine. Leave the lid open for some time to allow the interior of the machine to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. Select the new programme, temperature, any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Drain/Reset” button cancels a programme before the end. • Press the “Drain/Reset” button for at least 3 seconds. [. . . ] • This option is particularly recommended for the programmes “Synthetics”, “Daily load” and “Delicates”. • It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. • If you select “Rinse Hold”, do not leave items to soak for too long. Note: The programme stops to “Rinse hold” at the time the “Rinse hold” symbol on the display lights up. [. . . ]