User manual WHIRLPOOL AWE 6625 PRODUCT FICHE

[. . . ] Textiles made of linen, silk, wool and viscose marked as “handwashable”. 3. 0 Yes 600 Wool cold - 40°C - 40 °C 1. 0 Yes 600 400 2) 600 600 600 Handwash 30 - 40°C 30 - 40 °C 1. 0 5. 0 5. 0 1. 0 Yes Rinse & Spin Spin Gentle spin Drain — — — — Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. [. . . ] Drain only - no spinning. — — — — — — N. B. Please avoid excessive detergent dosing. Whirlpool is a registered trademark of Whirlpool USA 5019 312 10577 CONSUMPTION DATA Temperature Programme Cotton Cotton ** Cotton Synthetics Synthetics Delicates Daily load Quickwash Wool Handwash Handwash (°C) 95 60 40 60 40 40 40 30 40 40 30 (kg) 5. 0 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 (l) 50* 45 55 50* 45 50 40 35 55 40 40 (kWh) 1. 70 0. 85 0. 55 0. 80 0. 45 0. 55 0. 45 0. 40 0. 55 0. 40 0. 30 Load Water Energy Approx. Programme Duration (hours : minutes) 2:05 2:30 2:00 1:30 1:15 0:45 1:00 0:30 0:45 0:35 0:35 PROGRAMME START Turn on the tap and press the “Start/Pause” button . The lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phase is finished, the corresponding indication goes off. • Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show that the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. Select the new programme, any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the lid can be opened. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. Add detergent and additives into the dispenser to no more than the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Stain remover agents • Anti-scale agents (if necessary) 3. [. . . ] Add detergent and additives into the dispenser to no more than the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Stain remover agents • Anti-scale agents (if necessary) 3. Turn the programme selector to the desired programme and temperature. The lamp next to the “Start/Pause” button flashes. [. . . ]