User manual WHIRLPOOL AWE 6729 PRODUCT FICHE

[. . . ] Textiles made of linen, silk, wool and viscose marked as “handwashable”. Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. [. . . ] Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Alternative method of terminating programme after “Rinse hold”. Yes – – Yes – – – – – – – – – Yes 1) Yes Yes Yes 1) Yes Yes Yes Yes Yes – – – – i i i i Special options Spin speed Rinse reduction hold X00/X00 Arrêt cuve tours pleine i i i i i i i i Spin Speed rpm max. 1000 2) – Cotton with prewash 95°C Cotton 40 - 60 - 95°C Cotton rapid 60 °C Synthetics with prewash 60°C Synthetics 30 - 40 - 60°C Delicates 30°C Quick wash 15' 30°C Wool Cold - 40°C Handwash 40°C Rinse & Spin Spin Gentle Spin Drain Coton 95°C Coton 40 - 60 - 95°C Coton Rapide 60 °C Synthétique 60°C Synthétique 30 - 40 - 60°C Délicat 30°C Chrono 30°C Laine Froid - 40°C Lavage main 40°C Rinçage & Essorage Essorage Essorage doux Vidange – – – – 5. 0 5. 0 5. 0 3. 0 3. 0 1. 5 3. 0 1. 0 1. 0 5. 0 5. 0 1. 0 – i i i i i i – – – i i i i i i i i – i i i i i i – – – N. B. Please avoid excessive detergent dosing. Yes = dosing required / i = optional 5019 312 11155 CONSUMPTION DATA Temperature Programme Cotton Cotton** Cotton** Cotton Cotton** Cotton rapid Synthetics Synthetics Delicates Quick wash 15' Wool Handwash (°C) 95 60 60 40 40 60 60 40 30 30 40 40 (kg) 5. 0 5. 0 2. 5 5. 0 2. 5 5. 0 3. 0 3. 0 1. 5 3. 0 1. 0 1. 0 (l) 50* 47 32 47 32 47 50* 40 50 30 55 40 (kWh) 1. 70 0. 89 0. 68 0. 65 0. 52 0. 95 0. 90 0. 50 0. 55 0. 15 0. 55 0. 40 Load Water Energy Approx. Programme Duration (hours : minutes) 2:05 2:45 2:10 2:00 1:45 2:10 2:05 1:50 0:41 0:15 0:45 0:35 PROGRAMME START Open the tap and press the “Start(Pause)” button. The indication lamp next to the “Start(Pause)” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption refer to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programmes for Energy Label. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and checkm that they are properly locked. 2. Add detergent and eventual additives as described on the front page and in your Instructions for use. 4. Turn the programme selector to the desired programme and temperature. [. . . ] ** Reference Programmes for Energy Label. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and checkm that they are properly locked. 2. Add detergent and eventual additives as described on the front page and in your Instructions for use. 4. Turn the programme selector to the desired programme and temperature. The lamp next to the “Start(Pause)” button flashes. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. [. . . ]