User manual WHIRLPOOL AWE 6730/P PRODUCT FICHE

[. . . ] In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Alternative method of terminating programme after “Rinse Hold”. — — — — — — N. B. [. . . ] Please avoid excessive detergent dosing. Whirlpool is a registered trademark of Whirlpool USA 5019 312 10579 CONSUMPTION DATA Temperature Programme Cotton Cotton ** Cotton Synthetics Synthetics Delicates Daily load Quickwash Wool Handwash Handwash (°C) 95 60 40 60 40 40 40 30 40 40 30 (kg) 5. 0 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 (l) 50* 48 55 50* 45 50 40 35 55 40 40 (kWh) 1. 70 0. 85 0. 55 0. 80 0. 45 0. 55 0. 45 0. 40 0. 55 0. 40 0. 30 Load Water Energy Approx. Programme Duration (hours : minutes) 2:05 2:30 2:00 1:30 1:15 0:45 1:00 0:30 0:45 0:35 0:35 programme will terminate automatically with the final spin cycle for the present wash programme. • If you do not wish to spin the clothes, turn the programme selector to the “Drain” programme and press the “Start/Pause” button . “Intensive Rinse” button • The amount of water is increased to ensure a more intensive rinse. • This option is particularly suitable for areas with very soft water, washing baby linen and for people with skin allergies. PROGRAMME START Turn on the tap and press the “Start/Pause” button . The lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phase is finished, the corresponding indication goes off. • Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. Turn the programme selector to the desired programme and temperature. The lamp next to the “Start/Pause” button flashes. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. “Prewash” button • Only sensible for heavily soiled loads (for example sand, granular dirt). The cycle time increases by approximately 20 min. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button the programme. to pause “Half load” button • Reduces water consumption, above all during rinsing. • Suitable for lightly soiled laundry and small loads (max. “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. [. . . ] “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the “Synthetics”, “Delicates” and “Daily load” programmes. • It is useful if you want to postpone spinning to a later time, or if you want to drain only. • If you select “Rinse hold”, do not leave items to soak for too long. [. . . ]