User manual WHIRLPOOL AWE 6761 PRODUCT FICHE

[. . . ] Most favourable programme in terms of combined water and energy consumption for washing cotton laundry. - Reference programme for the Energy Label. Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. [. . . ] Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Alternative method of terminating programme after “Rinse hold”. – Yes Yes 1) i i i max. 60°C 3. 0 i i i i max. 30 - 40 - 60°C Delikatne Syntetyczne 3. 0 – – – – Yes Yes Yes Yes i i i max. max. 30°C 30°C 1. 5 3. 0 1. 0 i i i i i i Szybki Wełniane/ Pranie rêczne 20 - 40°C 40 - 60°C i i i co Bawelna Płukanie i wirowanie Wirowanie Wirowanie delikatne Wypompowanie 5. 0 – – – – 5. 0 5. 0 1. 0 – – – – – – Yes – – – – i i – – – i i – – – i i i i – max. – Yes = dosing required / i = optional The Wool/Handwash cycles of this machine have been tested and approved by The Woolmark Company for the washing of Woolmark garments labelled as “machine wash” or “hand wash”provided that the garments are washed according to the instructions on the garment label and those issued in this programme chart. M0804 Whirlpool is a registered trademark of Whirlpool USA. 5019 312 11170 CONSUMPTION DATA Programme Cotton Cotton Cotton Synthetics Synthetics Delicate Speed 15’ Wool/Handwash Wool/Handwash Eco cotton** Eco cotton** Eco cotton Eco cotton** Temperature (°C) 95 60 40 60 40 30 30 40 20 60 60 40 40 Load (kg) 5. 0 5. 0 5. 0 3. 0 3. 0 1. 5 3. 0 1. 0 1. 0 5. 0 2. 5 5. 0 2. 5 Water (l) 50* 47 47 50* 40 50 30 40 40 47 32 47 32 Energy (kWh) 1. 70 0. 95 0. 64 0. 90 0. 50 0. 50 0. 15 0. 55 0:40 0. 95 0. 75 0. 65 0. 59 Approx. Programme Duration (hours : minutes) 2:05 2:20 2:05 2:05 1:50 0:41 0:15 0:35 0:30 2:45 2:10 2:00 1:45 PROGRAMME START Open the tap and press the “Start(Pause)” button. The blinking light next to the “Start(Pause)” button becomes constant. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press the “Reset” button for at least 3 seconds. The water is drained out; it may last a while until you can open the lid. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption refer to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programmes for Energy Label. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. [. . . ] ** Reference Programmes for Energy Label. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. 2. Add detergent and eventual additives as described on the front page and in your Instructions for use. 4. Turn the programme selector to the desired programme and temperature. The indication next to the “Start/Pause” button blinks. [. . . ]