User manual WHIRLPOOL AWE 8640 PRODUCT FICHE

[. . . ] Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. Textiles made of linen, silk, wool and viscose marked as “handwashable”. Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. [. . . ] Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Drain only - no spinning. Detergents and Additives Prewash Main Softener Wash Lavado en frío Special options Cold No wash Spin Max. Spin Speed rpm max. Exclusión centrif. Cotton with prewash 95 °C Cotton 40 - 60 - 95 °C Synthetics with prewash 60 °C Synthetics 30 - 40 - 60 °C Delicates 30 °C Quick wash 30 °C Wool Cold - 40 °C Handwash 30 - 40 °C Rinse & Spin Spin Gentle Spin Drain 5. 0 Yes 1) Yes  –  5. 0 – Yes 1) Yes    max. 2. 5 Yes  –  max. 2. 5 – Yes    max. 1. 5 3. 0 1. 0 1. 0 5. 0 5. 0 1. 0 – – – – – – – – – Yes Yes Yes Yes – – – –      – – –     – – – –        – max. Please avoid excessive detergent dosing. Yes = dosing required /  = optional Whirlpool is a registered trademark of Whirlpool USA. 5019 312 10749 CONSUMPTION DATA Temperature Programme (°C) Cotton Cotton** Cotton Synthetics Synthetics Delicates Quick wash Wool Handwash 95 60 40 60 40 40 30 40 40 (kg) 5. 0 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 1. 0 1. 0 (l) 50* 45 55 50* 45 50 35 55 40 (kWh) 1. 70 0. 85 0. 55 0. 80 0. 45 0. 55 0. 40 0. 55 0. 40 Load Water Energy Approx. Programme Duration (hours : minutes) 2:05 2:30 2:00 1:30 1:15 0:45 0:30 0:45 0:35 PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Prewash cycle increases programme duration by aproximately 20 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. [. . . ] Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. [. . . ]