User manual WHIRLPOOL AWE 9727/1 PROGRAM CHART

[. . . ] Curtains and delicate clothing, dresses, skirts, shirts and blouses. Normally soiled cotton jeanswear and garments made of jeanslike material such as trousers and jackets. Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. Offers highest economy in energy consumption by prolonged wash duration. [. . . ] From 1 hour on, the delay time can also be reduced by minutes. To cancel the “Start Delay” . . before you press the “Start/Pause” button: • Select another programme or press the “Reset” button. . . after having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 seconds - the start delay time disappears from the display. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. LOCK BUTTON You can lock the buttons of the control panel against improper use (e. g. • Press the temperature and spin speed button simultaneously and hold them for at least 3 seconds. The key symbol on the display lights up. • To unlock the buttons again: proceed in the same way. RED INDICATIONS ON THE DISPLAY “Water tap closed” The appliance has no or insufficient water supply. Open the water tap: if the indications still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your “Instructions for Use”; if the fault persists, contact our After Sales Service. PROGRAMME END • The symbols of the programme sequence indicator are dark, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Open lid and drum and unload the machine. [. . . ] Chlorine or perborate bleaches must not be used!“Intensive Rinse” button • More water is added and rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen and helping people with allergies. Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. [. . . ]