User manual WHIRLPOOL AWE6762

[. . . ] Refreshes briefly worn outer clothing made of cotton, artificial fibers and blends with cotton. Use lovest recommended detergent amount. Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles made of silk, linen, wool and viscose marked as handwashable Normally soiled cotton laundry. At 40°C and 60°C standard cotton programme and most favourable programme in terms of combined water and energy consumption for washing cotton laundry. [. . . ] PROGRAMME START Open the tap and press the “Start(Pause)” button. The indication lamp next to the “Start(Pause)” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. • Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel a running programme before the end”. FAILURE INDICATIONS In case of any failures or irregularities, consult the “Troubleshooting Guide” in your Instructions for Use. “Water tap closed” No or not sufficient inlet water. “Service” Failure or malfunction of an electrical component. “Clean pump” Waste water is not pumped out. Spin speed on programme sequence indicator blinks: Unbalance during spinning PROGRAMME END • The “Door open” indicator lights up, and the display shows “End”. After about a quarter of an hour, the washing machine will switch off completely to save energy. 1. 1Turn the programme selector to the “Off/O” position. 3. Open lid and drum and unload the machine. 4. Leave the lid open for some time to allow the interior of the machine to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start(Pause)” button to pause the programme. 2. Select the new programme, temperature, any options and another spin speed if you want. 3. Press the “Start(Pause)” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. [. . . ] “Intensive rinse” button • More water is added and rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen and helping people with allergies. “Rinse hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. [. . . ]