User manual WHIRLPOOL AWE9999GG

[. . . ] in addition to your detergent. 6. 5 Save energy by selecting a lower wash temperature and adding an oxygen-based bleach product, 4. 0 Gentle wash programme to avoid graying or yellowing of your laundry. Use heavy duty detergent, if necessary also stain removers or bleaches on oxygen basis. Black and dark garments made of cotton, cotton blends and polyester. White and pastel shaded garments made of delicate fabrics. 4. 0 Special programme to reduce colour fading and local discolouration. [. . . ] In this case, the washing machine will tumble the laundry regularly to keep it fresh, until the selected cycle end time has expired. During tumbling, the display will show an animation. The tumbling phase can be stopped at any time either by pressing any button or by rotating the programme selector; the animation will stop and the door will unlock in about 1 minute as indicated on the display. Load (kg) 3. 0 6. 5 6. 5 6. 5 3. 0 3. 0 1. 5 1. 0 4. 0 6. 5 4. 0 4. 0 6. 5 2. 5 3. 0 6. 5 3. 25 6. 5 3. 25 Water (l) 45 55* 51 51 54* 50 50 40 41 51 67 41 51 19 30 48 34 48 34 without “Rapid” Energy (kWh) 0. 43 1. 90 1. 10 0. 67 0. 85 0. 50 0. 55 0. 55 0. 58 0. 65 0. 50 0. 58 0. 84 0. 43 0. 15 0. 67 0. 57 0. 65 0. 46 Approx. Programme Duration (hrs : min) without “Rapid” with “Rapid” 1:00 2:35 2:30 2:20 1:55 1:40 0:45 0:35 1:30 2:45 1:20 1:40 4:00 1:00 0:15 4:00 2:30 3:15 2:30 – 2:00 1:45 1:30 1:14 0:59 – – 1:10 – 1:00 1:10 – – – – – – – variations in load and temperature of inlet water, the remaining time is newly calculated in certain programme phases. If this is the case, an animation appears on the time display. “LID OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel a running programme before the end”. CHILD LOCK BUTTONS You can lock the buttons of the control panel against improper use (e. g. • Press both of the child lock buttons simultaneously and hold them for at least 3 seconds. The key symbol on the display lights up. • To unlock the buttons again: proceed in the same way. FINISH ON TIME FAILURE INDICATIONS In case of any failures or irregularities, consult the “Troubleshooting Guide” in your Instructions for Use. “Water tap closed” No or not sufficient inlet water. “Service” Failure or malfunction of an electrical component. “Clean pump” Waste water is not pumped out. Spin speed on display blinks: unbalance during spinning Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption refer to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Standard Cotton programme and basis for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature. PROGRAMME END • The “Door open” indication lights up and the display shows “End”. After about a quarter of an hour, the washing machine will switch off completely to save energy. 1. Turn the programme selector to the “Off/O” position. 3. Open lid and drum and unload the machine. [. . . ] 2. Select the new programme, temperature, any options and another spin speed if you want. 3. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL A RUNNING PROGRAMME BEFORE THE END The “Reset/Drain” button cancels a programme before the end. [. . . ]