User manual WHIRLPOOL AWECO 9544 PRODUCT FICHE

[. . . ] This programme (40ºC) is tested and approved by The Woolmark Company for handwashable wool. Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. [. . . ] Do not use liquid detergent when activating the “Start delay”. • Select programme, temperature and options. • Press the “Start Delay” button to select the delay time by 1 to 23 hours; • Press the “Start/Pause” button. The indication light over the “Start delay” button flashes and the countdown of the delay time begins. The dot between hours and minutes of the delay time indicated flashes. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • Once having pressed the “Start/Pause” button, the number of hours preselected can be reduced by pressing and holding the “Start delay” button. From 1 hour on, the delay time can also be reduced in steps of 10 minutes. To cancel the “Start delay” . . before you press the “Start/Pause” button: • Turn the programme selector to another position or press the “Reset” button. . . after having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 second - the start delay time dissapears from the time display. PROGRAMME START Open the tap and press the “Start/Pause” button. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press the “Reset” button for at least 3 seconds; “rES” appears on the display. Any existing water is drained out before the lid can be opened. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE LID AND SELECT THE PROGRAMME Add detergent as indicated an the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme. The display shows the programme duration in hours and minutes as well as the predefined temperature. The “Start/Pause” button flashes. [. . . ] “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. Increases the cycle time by approximately 15 min. • Do not use liquid detergent for the main wash when activating the Prewash option. “Intensive Rinse” button • More water is added and rinse cycle is prolonged. [. . . ]