User manual WHIRLPOOL AWF 592 INSTALLATION

[. . . ] ISTRUZIONI DI MONTAGGIO DELLE LAVATRICI INTEGRABILI ASSEMBLY INSTRUCTIONS FOR BUILT-IN WASHING MACHINES MONTAGEANLEITUNG FÜR EINBAUBAREWASCHMASCHINEN INSTRUCTIONS DE MONTAGE DES LAVE-LINGE INTÉGRABLES INSTRUCCIONES DE INSTALACIÓN DE LAS LAVADORAS INTEGRABLES INSTRUÇÕES DE MONTAGEM DAS MÁQUINAS DE LAVAR ROUPA INTEGRÁVEIS MONTAGEINSTRUCTIES VAN INTEGREERBARE WASMACHINES MONTERINGSANVISNING FOR INTEGRERBARE VASKEMASKINER MONTERINGSANVISNINGAR FÖR INBYGGNADSBARA TVÄTTMASKINER ANKASTRE ÇAMAŞIR MAKİNELERİ İÇİN MONTAJ TALİMATLARI IT EN DE FR ES PT NL DK SE TR IT EN DE FR ES PT NL DK SE TR Pagina Page Seite Page Página Página Bladzijde Side Sida Sayfa 1 4 7 10 13 16 19 22 25 28 ASSEMBLY INSTRUCTIONS FOR BUILT-IN WASHING MACHINES IMPORTANT - This machine complies with current safety regulations governing electrical appliances and, to ensure user safety, it must be installed by a qualified technician as required by current legislation Size of cabinet Applying the panel The minimum dimensions of the cabinet are: height 820 mm, width 600 mm, depth 584 mm (fig. The panel may be attached to the left- or right-hand side of the washing machine (fig. 2) The machine is supplied fitted for a left-hand side panel attachment as the right-hand side is fitted with the push-pull lock (upper part) and the rubber pad (lower part). [. . . ] If the height of the baseboard must be increased, the height of the wooden panel must be reduced. 4 Place the template of the inner side of the panel and match the height of the baseboard with the lower edge of the panel (fig. Make sure the template is horizontally centred with reference to the vertical lines marked at the ends. After placing the template in the correct position, trace the positions of the following holes, pushing in with the tip of your pencil: • holes for the hinges and hinge screws (fig. 4) • holes for fixing the metal plate (if the magnetic lock is used), or the hook for the push-pull lock (fig. 4, A - B) Applying the panel elements and fixing the panel 1) Drill the holes for the hinges (fig. 5), the hook for the pushpull lock (fig. 5), or the metal plate if you decide to use the magnetic lock (fig. 6), and the holes for fixing the hinges (fig. 2) The 13 mm depth of the 2 mm holes, for fixing the hinges and a metal plate for the magnet lock, only applies to the solid wood panel. For the chipboard panel, simply drill the upper coating – fig. 3) Screw the two hinges to the panel (fig. 7) 4) Mount the hook for the push-pull lock or the metal plate for the magnet lock on the side opposite the hinges (fig. 5) Fix the panel to the washing machine following the instructions shown in fig. If, after applying the panel to the washing machine, it is slightly inclined or off-centre with respect to the front of the machine, correct its position by adjusting the mobile part of the hinges (fig. [. . . ] In some cases, the baseboard is not continuous but limited to the width of the washing machine. In this case, the kitchen baseboard can be fixed to the washing machine baseboard with 4 screws, respecting the 4 reference marks (see fig. When applying the kitchen baseboard, the washing machine baseboard may not be removed or adapted as, for reasons of safety, it must remain as it is, in one piece and fixed to the washing machine. 6 [. . . ]