User manual WHIRLPOOL AWG 3102C PRODUCT FICHE

[. . . ] 1. 7 2. 0 Outer clothing worn for short periods and made of cotton, polyester, polyamide and cotton blends. Slightly to normally soiled garments made of cotton and/or synthetics. Slightly soiled garments in cotton and/or synthetics washable only in cold water. Same as the last rinse and the final spin in the “Cotton” programme. [. . . ] M0402-M0403-M0404-M0405). Whirlpool is a registered trademark of Whirlpool USA 5019 301 20139 Black process 45. 0° 150. 0 LPI 30120139GB. fm Page 2 Monday, September 17, 2007 6:15 PM CONSUMPTION DATA Programme White Cotton / Antibacterial Cotton Cotton with “Eco”*** Cotton Synthetics Synthetics Daily load Quick wash Delicates Wool Handwash Temperature Load (°C) (kg) 90 3. 5 75 3. 5 60 3. 5 40 3. 5 60 1. 7 40 1. 7 40 2. 0 35 1. 7 30 1. 7 40 0. 75 30 1. 0 Water Energy (l) (kWh) 40** 1. 26 40 0. 80 40 0. 55 37 0. 40 39** 0. 80 39 0. 45 42 0. 30 30 0. 25 42 0. 24 44 0. 30 53 0. 17 Approx. programme duration (hours : minutes)* 1:23 1:15 1:52 1:40 1:36 1:32 1:20 0:35 0:39 0:42 0:47 START DELAY The “Start Delay” option allows you to programme machine activation at a later stage, for example at night when electricity is cheaper. Do not use liquid detergent when activating the “Start delay”. • Select the programme and options. • Press the “Start Delay” button to select programme start a delay time of 1 to 12 hours; . • Press the “Start” button The indicator next to the “Start Delay” button lights up, whereas the selection indicator flashes to signal the countdown of the remaining time. • At the end of the delay time the machine starts the set programme. The LED indicating the wash stage in progress lights up. • After pressing the “Start” , the number of hours preselected can be reduced by pressing and holding the “Start Delay” button. To cancel the “Start Delay”: Press the “Start Delay” button until all the indicator lights are off. PROGRAMME START Open the tap and press the “Start” . Turn the programme selector to “Off/O”. Select the new programme, any options and another spin speed if you want. Press the “Start” button again. The new programme resumes the wash programme from where the previous one was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END • Reset by turning the programme selector to “Off/0” and select the “Drain Spin” programme to remove the water remaining in the bowl before the door can be opened. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in the Instructions for Use. Turn the programme selector to the desired programme. The indicator of the predefined spin speed lights up; in case you want to set another spin speed, press the “Variable spin” button . SELECT ANY DESIRED OPTION Press the button(s) of any required option(s) - the respective indicator lights up. When the combination of programme and additional option(s) is not possible, the indicators switch off automatically. Unsuitable combinations of options are deselected automatically. [. . . ] “Easy Ironing” button • Can be used together with “Cotton”, “Synthetic” and “Daily load” programmes to make ironing easier. • Increases the water quantity and the clothes are spun very gently. “Intensive rinse” button • More water is added and the rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen, and helps people with allergies. “Rinse hold” button • The laundry remains in the last rinse water without the final spin cycle, to avoid creasing and prevent colours from changing. [. . . ]