User manual WHIRLPOOL AWG 4103 PROGRAM CHART

[. . . ] spin speed rpm Programme Temperature Care Labels Start PreIntensive Easy Rinse delay wash rinse Ironing hold Partenza PreRisciacquo Stiro Anti ritardata lavaggio Intensivo Facile Piega Cotton Cotton Cotone Cotone 75 - 90 °C 60 °C 30 - 40 °C 5. 0 5. 0 5. 0 2. 5 2. 5 Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Curtains and delicate clothing, skirts, shirts and blouses. Only woollens labelled with the Woolmark and identified as machine washable. [. . . ] The indicator next to the “Start” button lights up. The programme sequence indicator shows the current programme stage, running from left to right through Prewash, Wash, Rinse, Drain/Spin, End. “DOOR OPEN” INDICATOR At the end of a programme, the “End” indicator lights up signalling that the door can be opened. As long as a wash programme is running, the door remains locked and must not be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATORS “Service” indicator Lighting up of the “Service” indicator can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in the Instructions for Use; If the fault persists, contact our After-Sales Service. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. In domestic use, consumption data may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The time indicated on the display (if present) can deviate from the values in the table, because it takes into account the household * conditions applicable at that time. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference programme for energy label. “Clean pump” indicator The water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the filter”). “Water tap closed” indicator Machine water supply insufficient or lacking. Open the water tap; Turn the programme selector to “Off/0” and reset the programme. If the indicator remains on, refer to the “Troubleshooting Guide” in the Instructions for Use. “Door lock” indicator Lighting up of the indicator could be caused by the door not being properly closed. Turn the programme selector to “Off/0” and reset the programme. If the indicator remains on, refer to the “Troubleshooting Guide” in the Instructions for Use. [. . . ] • It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. • If you select “Rinse hold”, do not leave the laundry to soak for too long. Note: The programme stops to “Rinse hold” at the time the “Rinse Hold” light in the programme sequence indicator is on. The indicator next to the “Start” button flashes. [. . . ]