User manual WHIRLPOOL AWG 4107 PROGRAM CHART

[. . . ] Garments made of linen, silk, wool and viscose marked as “handwashable”. Outer clothing worn for short periods and made of cotton, polyester, polyamide and cotton blends. Slightly to normally soiled garments made of cotton and/or synthetics. [. . . ] As long as a wash programme is running, the door remains locked and must not be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATORS “Service” indicator Lighting up of the “Service” indicator can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in the Instructions for Use; If the fault persists, contact our After-Sales Service. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. In domestic use, consumption data may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The time indicated on the display (if present) can deviate from the values in the table, because it takes into account the household * conditions applicable at that time. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference programme for energy label. “Clean pump” indicator The water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the filter”). “Water tap closed” indicator Machine water supply insufficient or lacking. Open the water tap; Turn the programme selector to “Off/O” and reset the programme. If the indicator remains on, refer to the “Troubleshooting Guide” in the Instructions for Use. “Door lock” indicator Lighting up of the indicator could be caused by the door not being properly closed. Turn the programme selector to “Off/O” and reset the programme. If the indicator remains on, refer to the “Troubleshooting Guide” in the Instructions for Use. PROGRAMME END • Lighting up of the lamp on the wash sequence indicator means that the programme has ended and the door is unlocked. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. [. . . ] • If you select “Rinse hold”, do not leave the laundry to soak for too long. Note: The programme stops to “Rinse hold” at the time the “Rinse Hold” light in the programme sequence indicator is on. The indicator next to the “Start” button flashes. [. . . ]