User manual WHIRLPOOL AWG 6101/B PRODUCT FICHE

[. . . ] Do not plug the power supply with wet hands. Never touch the machine with wet hands or feet. Never open the detergent drawer while the device is running. Never force to open the door of the machine while the machine is running. [. . . ] That is because the softener with high density obstructs the siphon and prevents the flow of the softener. 12 You can use fluid detergents in all programs without pre-washing. For this, mount the fluid detergent level plate in the second compartment of the detergent drawer and arrange the amount of fluid detergent according to the levels on this plate. RUNNING THE MACHINE Program selection and features Select programmes and additional functions appropriate for your laundry with the help of the tables shown on pages 17. Start/Pause button Pressing this button you can start the programme you selected or put the programme in progress on pause. When the programme you selected starts its operation the lamp above the start/pause button will start lighting. When you wish to put the selected programme on pause press the start/pause button once. In order to restart the programme from the point it was put on pause at you will have to press the start/pause button once again. Turn off the water tap. 15 WARNING!In the event power is cut off at any stage of the wash programmes and then resupplied after a certain while your machine will continue the programme from the point it was interrupted at. Such a situation will not cause any harm to your machine. In the event power is cut off during the wash operation the door lock mechanism will release its hold after two minutes. If there is water in the machine do not open the door or the water will pour out. Keep pulling by pressing on the siphon lid inside the drawer pulled to its end, and remove the drawer from its place (DIAGRAM-2). Wash it up with water with the help of an old toothbrush. Collect the residues inside the drawer slot without letting them drop into the machine. After thoroughly drying the drawer put it back in its place reversing the removal procedure. DIAGRAM-1 19 DIAGRAM-2 SIPHON PLUG Pull out the detergent drawer. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. Check if it placed properly. Siphon plug THE CABINET To clean the outside of the appliance, use a neutral detergent and a damp cloth. Please be careful not to use material that could damage the exterior surface of your machine. WARNING! If the machine is installed in a location where the ambient temperature can fall below 0 C, do the following when it will not be in use: Plug in the machine. Close the water tap and pull out the water inlet hose or hoses from the tap. Place the ends of the water drain and water inlet hoses in a cup on the ground. Adjust the program knob to “Draining” program. [. . . ] Press the start/pause button. In order to stop the foam, dilute one table-spoon of softener in half liter of water and pour it in the detergent drawer. Press the start/pause button after 5-10 minutes. Arrange the amount of the detergent properly in the next washing process. Use only the detergents produced for full automatic machines. (see Table-1) Use more detergent according to the detergent. Wrong detergent has been used. The washing result is bad. Your laundry too dirty for the program you have selected. The amount of detergent used is not sufficient. 24 FAILURE PROBABLE CAUSE Clothes exceeding the maximum capacity has been filled in your machine. The washing result is not good. Your water may be hard. [. . . ]