User manual WHIRLPOOL AWG 6122 B PRODUCT FICHE

[. . . ] Do not insert a plug with damaged or broken cord into the socket. If the cord is damaged it should be replaced by the manufacturer or appointed service agent in order to avoid a hazard. Never remove the plug from the socket by pulling from the cord section. Do not plug the power supply with wet hands. [. . . ] When you wish to put the selected programme on pause press the start/pause button once. The programme end lamp will light up. Bring the programme knob to the STOP (off) position. The door lock of your machine will automatically release about two minutes after the programme has finished. You can open the door and take out the laundry by pulling the door handle towards yourself. After you have taken out the laundry leave the door open so that the machine interior can dry. Turn off the water tap. 15 WARNING!In the event power is cut off at any stage of the wash programmes and then resupplied after a certain while your machine will continue the programme from the point it was interrupted at. Such a situation will not cause any harm to your machine. In the event power is cut off during the wash operation the door lock mechanism will release its hold after two minutes. If there is water in the machine do not open the door or the water will pour out. If you wish to take out your laundry you can do so by draining the water inside the machine following the instructions explained in the section “cleaning the pump filter” on pages 18 and 19. After you have cleaned the pump, fit the filter cover by rotating clockwise. Do not forget that if you do not fit in the filter cover properly, it will leak water. 18 WARNING! Danger of being scalded!Since the water inside the pump maybe hot, wait for it to cool. DETERGENT DRAWER Detergents may cause residue buildup in the detergent drawer and in its slot over time. Take out the detergent drawer periodically to clean up the accumulated residue. In order to take out the drawer: Pull the drawer to its end (DIAGRAM-1). Keep pulling by pressing on the siphon lid inside the drawer pulled to its end, and remove the drawer from its place (DIAGRAM-2). Wash it up with water with the help of an old toothbrush. Collect the residues inside the drawer slot without letting them drop into the machine. After thoroughly drying the drawer put it back in its place reversing the removal procedure. DIAGRAM-1 DIAGRAM-2 SIPHON PLUG Pull out the detergent drawer. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. [. . . ] Press the start/pause button. In order to stop the foam, dilute one table-spoon of softener in half liter of water and pour it in the detergent drawer. Press the start/pause button after 5-10 minutes. Arrange the amount of the detergent properly in the next washing process. Use only the detergents produced for full automatic machines. (see Table-1) Use more detergent according to the detergent. Wrong detergent has been used. The washing result is bad. Your laundry too dirty for the program you have selected. The amount of detergent used is not sufficient. 24 FAILURE PROBABLE CAUSE Clothes exceeding the maximum capacity has been filled in your machine. The washing result is not good. Your water may be hard. [. . . ]