User manual WHIRLPOOL AWG 680-1/WP INSTRUCTION FOR USE

[. . . ] AWG 680 GB PRIOR TO THE FIRST USE OF THE WASHING MACHINE 1. Removal of the transport bracket The washing unit is firmly connected with the cabinet during the transport. Prior to switching the washing machine on, it is necessary to remove the packaging and all polystyrene plinths as well as the transport bracket from the back of the washing machine (see the chapter ”How to remove the transport bracket”). There is a danger of serious damages to the washing machine if is used without removing the transport bracket. [. . . ] When washing cotton and resistant synthetics, the program does not end after final spinning finish but the drum goes on reversing up to circa 3 min (its rotation alters in one and another direction), which helps to release the laundry after spinning. Spinning has an interrupted start-up - the drum starts and stops running several times - it is so called interval spinning with an increased spinning efficiency. If you set the spinning speed knob to the washing machine will stop before the final spinning and the laundry stays floating in water. Front part of the top frame and the cabinet can get warm from the electric door lock, which is not a fault. INTERRUPTING THE WASH PROGRAMME If you want to change selected programme 1. Switch OFF the washing machine by adjusting the ON/OFF knob to the position ”O”. Select a new programme using the selector knob 3. Adjust the required temperature with the temperature selector knob. Switch ON the washing machine by turning ”ON/ OFF” knob to required spinning speed. If you want to add another piece of laundry, you can interrupt the washing cycle at any time: 1. Switch OFF the washing machine with the ON/OFF knob. The door is electrically closed during the whole washing cycle, so you must wait oneminute approx. Open the lid, the inner door and the drum flaps. Close the drum flaps, the inner door and the lid. Switch ON the washing machine with the ON/OFF knob and the washing machine will continue the selected wash cycle. End of the wash programme The programme is completed when the programme selector knob is at the end of the spin cycle . Switch OFF the washing machine by ON/OFF button. Turn off the water tap and disconnect the machine from the mains. The safety device will keep the door locked at the end of the wash cycle for approximately one minute. Open the machine lid, the inner door and drum flaps . Remove the laundry, pay attention not to drop small items between the tub and the cabinet. 9 10 HOW TO SELECT THE WASH PROGRAMME Programme selector I yes yes yes yes yes yes yes - 40o C - 40 C o Type of load II yes yes yes yes yes l yes l - 60 C o Max. load Button 1/2 yes yes - 40 C o Dispenser Temperature Spinning speed 800 800 800 - 500 120 - 800 120 - 800 - 400 400 120 - 800 120 - 800 - Programme length 130 min. 3 min. Cotton white with prewash (max. [. . . ] The machine will stand on its wheels for easy transportation. Pull the lever of trolley parallely to the floor - do not lift it. Notice: 1) The trolley has to be put back in its original position during operation. 2) We recommend to not position the washing machine on carpet or other floors that would obstruction the proper ventilation through the bottom of the machine. [. . . ]