User manual WHIRLPOOL AWG 800/1 PROGRAM CHART

[. . . ] 90° 1 2 3 4 B C 5 6 A B D 7 D Cotton with prewash Cotton Heavily soiled, long wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc. ). Normally soiled bed linen, table linen and underwear, towels, shirts etc. Average to heavily soiled, long wearing and temperature stable textiles in cotton and linen. Slightly soiled bed linen, table linen and underwear, towels, shirts etc. [. . . ] Alternative method for terminating the “Synthetic”, “Delicate” and “Wool” programme and unload the laundry earlier. 5. 0 5. 0 Coloured Cotton Quick wash Special rinse for cotton wash Drain + Spin Synthetic with prewash Synthetic Rinses Special rinse for synthetic fabrics Drain + Spin Wool Drain + Spin for wool 5. 0 5. 0 5. 0 5. 0 2. 5 2. 5 2. 5 2. 5 2. 5 1. 0 1. 0 — — — — yes — — — — — — yes yes — — yes yes — — — yes — h h h — h h h h — h — h — — — — h h h h — h — h h h h h h h h h h h h h — — h h — — — — — Max. 40° — — — — — — — — — — — Whirlpool is a registered trademark of Whirlpool USA 5019 301 20080 Black process 45. 0° 100. 0 LPI 3gb20080. fm Page 2 Tuesday, July 8, 2003 4:36 PM CONSUMPTION DATA Temperature Selector (°C) 2 - Cotton 3 - Cotton 3 - Cotton 6 - Synthetics 6 - Synthetics 7 - Wool 90° 60° 40° 60° 40° 40° Load (kg) 5. 0 5. 0 5. 0 2. 5 2. 5 1. 0 Water (l) 55 49 49 52 52 52 Energy (kWh) 1. 80 0. 95 0. 50 0. 78 0. 42 0. 24 Approx. Programme Duration (hours:minutes) 2:19 2:00 1:50 1:10 1:00 0:45 Programme “No Spin” button • Especially for delicate garments to avoid wear and tear caused by the spin. Note: in the “Cotton” and “Synthetics” programmes the machine will perform a short spin at a low speed, even if the spin cycle has been disabled, so as to optimise rinsing operations. “Half Load” button (depending on model) • Reduces water consumption above all during rinsing. • Suitable for lightly soiled laundry and small loads (max 2. 5 kg). DOOR LOCK The door locks automatically after the programme start until the end of the programme. If the programme selector is moved to the “Stop” position or if the electricity supply is interrupted, then after approximately two minutes the door is released. In this case do not open the door, because hot water could come out of the door. PROGRAMME RESELECTION To change a programme when a cycle has already begun: 1. Switch off the appliance by pressing the button. Start the programme by pressing the button. “ON/OFF” TO INTERRUPT THE RUNNING PROGRAMME To interrupt the running programme and continue it at a later time: 1. After the desired interval has passed, press the “ON/OFF” button again. At the end of the programme the programme selector moves to the “Stop” position. To unload the machine wait for the door to unlock (approx. Switch off the appliance, open the door and unload the washing. Close the tap and leave the door ajar to allow the drum to dry out. NOTES AND INDICATIONS FOR USE • SPIN SPEED CONTROL Spin speed may be reduced automatically or may even be excluded in case of small loads containing highly absorbing garments (e. g. This reduces damage to fabric and to the machine and prevents excessive vibration and noise in the machine due to an unbalanced load: by selecting high spin speeds the noise level increases. [. . . ] SELECT ANY DESIRED OPTION “Intensive Rinse” button (depending on model) • More water and a longer time in rinse cycle is added. • This option is especially recommended in areas with extremely soft water, for baby linen and helps people with skin allergies. “Rinse Hold” button in synthetic and wool programmes only (depending on model) • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programme “Synthetics” or “Delicate”. • This function is particularly useful if you want to postpone spinning to a later time or when you do not wish to spin the clothes. [. . . ]