User manual WHIRLPOOL AWG 852 PROGRAM CHART

[. . . ] Programme for treating wash with starch or softener. The programme ends with a long spin cycle. Alternative method for unloading laundry earlier. [. . . ] Programme Duration (hours:minutes) 2:39 2:40 2:19 1:02 0:43 0:42 (eco) “Eco Wash” button (depending on model) • Reduces the temperature to 60° when the thermostat is set to a higher temperature. TO INTERRUPT THE RUNNING PROGRAMME To interrupt the running programme and continue it at a later time: 1. After the desired interval has passed, press the “ON/OFF” button again. At the end of the programme the programme selector moves to the “Stop” position. To unload the machine wait for the door to unlock (approx. Switch off the appliance, open the door and unload the washing. Close the tap and leave the door ajar to allow the drum to dry out. NOTES AND INDICATIONS FOR USE • SPIN SPEED CONTROL Spin speed may be reduced automatically or may even be excluded in case of small loads containing highly absorbing garments (e. g. This reduces damage to fabric and to the machine and prevents excessive vibration and noise in the machine due to an unbalanced load: by selecting high spin speeds the noise level increases. CLEANING THE FILTER To ensure an impeccable function of the pump, check the filter regular and clean it if necessary. THERMOSTAT KNOB This is set by turning the knob until it reaches the desired temperature. Programme “No Spin” button • Especially for delicate garments to avoid wear and tear caused by the spin. Note: in the “Cotton” and “Synthetics” programmes the machine will perform a short spin at a low speed, even if the spin cycle has been disabled, so as to optimise rinsing operations. DOOR LOCK The door locks automatically after the programme start until the end of the programme. If the programme selector is moved to the “Stop” position or if the electricity supply is interrupted, then after approximately two minutes the door is released. In this case do not open the door, because hot water could come out of the door. PROGRAMME RESELECTION To change a programme when a cycle has already begun: 1. Switch off the appliance by pressing the “ON/OFF” button. Start the programme by pressing the button. “ON/OFF” Prewash cycle increases programme duration by approx. [. . . ] • Suitable for lightly soiled laundry and small loads (max 2. 5 kg). Note: reduce the detergent quantity. “Intensive Rinse” button (depending on model) • More water and a longer time in rinse cycle is added. • This option is especially recommended in areas with extremely soft water, for baby linen and helps people with skin allergies. [. . . ]