User manual WHIRLPOOL AWG 852/1 PROGRAM CHART

[. . . ] 90° Programme selector knob Programme Care Labels Type of wash/Notes Max. Load kg 1 2 3 4 A B C 5 6 7 8 A B D Cotton with prewash Cotton Heavily soiled, long wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc. ). Normally soiled bed linen, table linen and underwear, towels, shirts etc. Average to heavily soiled, long wearing and temperature stable textiles in cotton and linen. [. . . ] Rinse program, ending with a spin cycle. Programme for treating wash with starch or softener. The programme ends with a long spin cycle. Alternative method for terminating the “Synthetic”, “Delicate” and “Wool” programme and unload the laundry earlier. Whirlpool is a registered trademark of Whirlpool USA. 5019 301 20076 Black process 45. 0° 100. 0 LPI 3gb20076. fm Page 2 Wednesday, July 9, 2003 11:24 AM CONSUMPTION DATA Temperature Selector (°C) 2 - Cotton 3 - Cotton 4 - Cotton 5 - Synthetics 7 - Synthetics 8 - Wool 90° 60° 45° 60° 45° 40° Load (kg) 3. 5 3. 5 3. 5 1. 5 1. 5 1. 0 Water (l) 49 48 48 35 37 37 Energy (kWh) 1. 72 0. 85 0. 53 0. 80 0. 40 0. 28 Approx. Programme Duration (hours:minutes) 2:39 2:40 2:19 1:02 0:43 0:42 Programme “Half Load” button (depending on model) • Reduces water consumption above all during rinsing. • Suitable for lightly soiled laundry and small loads (max 2. 5 kg). DOOR LOCK The door locks automatically after the programme start until the end of the programme. If the programme selector is moved to the “Stop” position or if the electricity supply is interrupted, then after approximately two minutes the door is released. In this case do not open the door, because hot water could come out of the door. PROGRAMME RESELECTION To change a programme when a cycle has already begun: 1. Switch off the appliance by pressing the “ON/OFF” button. Start the programme by pressing the “ON/OFF” button. TO INTERRUPT THE RUNNING PROGRAMME To interrupt the running programme and continue it at a later time: 1. After the desired interval has passed, press the “ON/OFF” button again. At the end of the programme the programme selector moves to the “Stop” position. To unload the machine wait for the door to unlock (approx. Switch off the appliance, open the door and unload the washing. Close the tap and leave the door ajar to allow the drum to dry out. NOTES AND INDICATIONS FOR USE • SPIN SPEED CONTROL Spin speed may be reduced automatically or may even be excluded in case of small loads containing highly absorbing garments (e. g. This reduces damage to fabric and to the machine and prevents excessive vibration and noise in the machine due to an unbalanced load: by selecting high spin speeds the noise level increases. CLEANING THE FILTER To ensure an impeccable function of the pump, check the filter regular and clean it if necessary. [. . . ] • This option is particularly recommended for the programme “Synthetics” or “Delicate”. • This function is particularly useful if you want to postpone spinning to a later time or when you do not wish to spin the clothes. To terminate the “Rinse Hold” option (depending on model) • Press the Rinse hold button again; the load will be spun according to the selected programme. If you do not wish to spin the clothes, turn the programme selector knob to the drain programme, after pressing the “No Spin“ button. [. . . ]