User manual WHIRLPOOL AWG/B M7120 S PRODUCT FICHE

[. . . ] Outer clothing worn for short periods and made of cotton, polyester, polyamide and cotton blends. Slightly to normally soiled garments made of cotton and/ or synthetics. Slightly soiled garments in cotton and/or synthetics washable only in cold water. Same as the last rinse and the final spin in the “Cotton” programme. [. . . ] M0402-M0403-M0404-M0405). Whirlpool is a registered trademark of Whirlpool USA 5019 301 20143 Black process 45. 0° 150. 0 LPI 30120143GB. fm Page 2 Thursday, September 13, 2007 10:42 AM CONSUMPTION DATA Programme White Cotton / Antibacterial Cotton Cotton*** Cotton Synthetics Synthetics Delicates Wool Handwash Quick wash Daily load Temperature Load (°C) (kg) 90 3. 5 75 3. 5 60 3. 5 40 3. 5 60 1. 7 40 1. 7 30 1. 7 40 0. 75 30 1. 0 35 1. 7 40 2. 0 Water Energy (l) (kWh) 40** 1. 26 40 0. 80 40 0. 55 37 0. 40 39** 0. 80 39 0. 45 42 0. 24 44 0. 30 53 0. 17 30 0. 25 42 0. 30 Approx. programme duration (hours : minutes)* 1:23 1:15 1:52 1:40 1:36 1:32 0:39 0:42 0:47 0:35 1:20 START DELAY The “Start Delay” option allows you to programme machine activation at a later stage, for example at night when electricity is cheaper. Do not use liquid detergent when activating the “Start delay”. • Select the programme and options. • Press the “Start Delay” button to select programme start a delay time of 1 to 16 hours; • Press the “Start” button. The indicator next to the “Start delay” button lights up, whereas the selection made is shown on the display. Its flashing indicates the countdown of the remaining time. • At the end of the delay time the machine starts the set programme. The icon indicating the wash cycle step being carried out at that moment is displayed. • After pressing the “Start”, the number of hours preselected can be reduced by pressing and holding the “Start Delay” button. To cancel the “Start Delay”: Press the “Start delay” button until the time indicated on the display is “00”; the selected programme will then start. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END • Reset by turning the programme selector to “Off/O” and select the “Drain/Spin” programme to remove the water remaining in the bowl before the door can be opened. Whirlpool is a registered trademark of Whirlpool USA Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. In domestic use, consumption data may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The time indicated on the display (if present) can deviate from the values in the table, because it takes into account the household * conditions applicable at that time. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference programme for energy label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in the Instructions for Use. Turn the programme selector to the desired programme. The indicator of the predefined spin speed lights up; in case you want to set another spin speed, press the “Variable spin” button. SELECT ANY DESIRED OPTION Press the button(s) of any required option(s) - the respective indicator lights up. When the combination of programme and additional option(s) is not possible, the indicators switch off automatically. Unsuitable combinations of options are deselected automatically. [. . . ] • This option is particularly suitable for areas with very soft water, washing baby linen, and helps people with allergies. “Easy Ironing” button • Can be used together with “Cotton”, “Synthetic” and “Daily load” programmes to make ironing easier. • Increases the water quantity and the clothes are spun very gently. “Rinse hold” button • The laundry remains in the last rinse water without the final spin cycle, to avoid creasing and prevent colours from changing. • This option is particularly recommended for the “Synthetics”, “Daily load” or “Delicates” programmes. [. . . ]